Electronics Forum | Thu Jun 22 12:25:02 EDT 2006 | vikkaraja
and type the following: optedt and press enter.Password for this is QMPM. Good luck and keep us posted.
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Tue Aug 04 13:44:05 EDT 2009 | swag
Check your DIP switch settings on new driver. Not sure about calibration. Try QMPM for password.
Electronics Forum | Tue Aug 04 14:43:12 EDT 2009 | kpm135
Thank you very much SWAG that password did the trick. Got us into the calibration menu and we were able to calibrate the z-axis and snugger height and got it to work. Thanks again
Electronics Forum | Tue Aug 04 10:43:48 EDT 2009 | kpm135
Thanks for the suggestions! It ended up being that a wire on the amplifier card in the lower drawer came loose and was making intermittent contact. Tightened all the wires down and the problem has gone away. Now we have a new problem. We had to repla
Electronics Forum | Fri Oct 04 13:14:13 EDT 2019 | ddfreeze
I need to access the calibration menu, does anyone have a password for it? having issues with the z axis hardware limit. doesn't appear the card is bad. board raises to camera and goes back down???
Electronics Forum | Tue Sep 20 15:00:26 EDT 2016 | awhite
Got it!!!!! On the main Operator Screen for the MPM UP2000, and under configuration (when logged-in under maintenance), it gives you ONLY the settings that the machine is set to....there are no drop-downs or options available to choose from. Very fr
| 1 |
