Electronics Forum | Wed Jun 02 11:19:18 EDT 2004 | black5629
I have a MPM3000, I have tried the multiple models still same problem. When you Teaching Board Stop Y, do you set the cross hair at the leading edge of the board?
Electronics Forum | Tue Sep 29 10:10:34 EDT 2015 | swag
We used to have a UP3000. Long time ago so I'm rusty but isn't there a setting for fid correction that you an program to occur after each board or after 5, 10, etc.? I thought I remembered doing offsets on ours as the camera was a little wacky (old
Electronics Forum | Fri Aug 11 11:18:20 EDT 2006 | chrisgriffin
I got a 3000 that is acting crazy. After a print, the board is unclamped and the Z-axis lowers. It continues to lower until it trips the limit switch. It is suppposed to move in the Y-axis to line up with the tracks while lowering in the Z-axis.
Electronics Forum | Wed Jun 02 11:33:00 EDT 2004 | Vinnie
I think you are right. Board stop on Y. Vision square is the stencil fiducials. So if you are using pads.... I am not sure. But why didnt you used board fiducials? none on the board?
Electronics Forum | Mon Apr 24 13:23:37 EDT 2006 | pjc
Use the photo sensor to stop boards instead of the hard-stop. There is also an ultrasonic sensor upgrade. A little more robust than optical. Y Snugger Tooling upgrade is kind of pricey and they like to do that in the plant. But, I've known that upgr
Electronics Forum | Mon Jul 30 10:22:57 EDT 2007 | swag
Sounds like your board stop sensor is not working properly so it's not seeing the y-stop/board edge when the board enters the center or the machine. You could try taking the camera cube cover off, jog the camera over a board then move the board back
Electronics Forum | Fri May 14 08:30:52 EDT 2004 | pjc
For any application- high-mix, low volume to low-mix high-volume: J.O.T. Automation board handling MPM UltraFlex 3000 printer CyberOptics SE300 3D post print inspector 2x Mydata Synergy II w/ Linear Magazines and Agilis feeders CyberOptics Flex
Electronics Forum | Mon Jul 30 17:32:34 EDT 2007 | chrisgriffin
When you teach the "teach boardstop Y" make sure the camera is seeing the leading edge of the board and not too close to the rails. It should calculate the pre-stop position correctly. I assume you have thoroughly checked the sensor. Also check th
Electronics Forum | Wed Sep 30 05:10:28 EDT 2015 | aemery
SWAG does make a good point. The tool he is talking about is located on setup page 1 in the vision box and is labeled FP Mode (Fine Pitch) mode. BY default the setting is "0" this means that once the machine is put into auto mode the camera or visio
Electronics Forum | Thu Jun 23 21:04:04 EDT 2005 | darby
If you have concluded that it is not a file storage problem you may wish to consider - When setting up a job the camera can move to virtually any position. This does not mean that the actuators on the stencil or board have enough travel to align the
.gif)
winsouce.jpg)