Electronics Forum | Thu Jul 02 17:06:39 EDT 2015 | aemery
Just to clarify, you are talking about the inner black box not driving down and not the pneumatic function that brings the tactile assembly closer to the stencil? Sometimes the pneumatic shafts get slightly bent and the assembly will not retract. T
Electronics Forum | Fri Jun 12 14:19:03 EDT 2015 | tdemon69
i have a up 3000 ultraflex. the lower half of the tactile sensor is stuck down. i have replaced the driver board, check wire down to drive board,check the fuse for power on the driver board.
Electronics Forum | Sat Jun 13 13:51:44 EDT 2015 | tnisbet
The problem could be the tactile motor, we have it in stock. Please contact sales@goppm.com and request a quote for part number CA-399.
Electronics Forum | Thu May 13 23:01:07 EDT 2004 | fastek
Unplug the tactile sensor and check the switch with an ohm meter. If the tactile sensor switch is good go in one of the drawers in the back of the machine and with the help of your schematics find the opto-module that controls the tactile sensor circ
Electronics Forum | Tue Aug 04 09:02:34 EDT 2009 | kpm135
We replaced the tactile sensor's linear actuator on a MPM Ultraprint 2000 HiE. Now we are getting a Tactile Hardware limit error every time we try to find the stencil height. I was hoping some one could explain why we're getting this error and any i
Electronics Forum | Thu May 13 16:54:55 EDT 2004 | Kuru
I just installed a used Tactile sensor unit, Now it now reads error "Tactile Sensor sensor never closed". If anyone knows or seen this problem pls help. I have adjusted the flag on the photosensor.The photosensor appear to be functioning but the step
Electronics Forum | Wed Apr 08 10:23:38 EDT 2009 | cyber_wolf
I am assuming this machine has a tactile sensor that mounts to the printing table. If the air connection or any of the wire connectors get under the rear rail it will cause the Z to fall. Also any bare wires on the tactile sensor that touch the prin
Electronics Forum | Fri Mar 18 18:51:59 EST 2005 | valuems
Hello Micheal We are looking for the procedure at this time. And there is no tactile sensor on any SPM made by MPM. The SPM's does not have sensor's on the head either. Any way we will send the procedures and the calibration blocks soon. harry
Electronics Forum | Thu Oct 20 13:34:08 EDT 2011 | babe7362000
I checked the housing and it can move up and down freely. I went into Cal and also moved it without a problem. The sensors in the digital I/O seem to be fine. I checked the voltage going to the driver card and it seems to be fine. I think I will s
Electronics Forum | Tue May 04 16:04:40 EDT 2004 | Kuru
Your are right my trackball was the problem, Now it resets and error on Tactile sensor. If anyone knows where I could get used parts beside MPM, please let know. Thanks
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
