Electronics Forum | Tue Jan 08 16:25:00 EST 2013 | eduardo3mx
hello I need your help I have a machine mpm ultraprint3000 with the damaged hard drive I made a copy to the hard drive of another machine the same, but I have problems with the x-axis origin does not, either the track center, and the stencil wiper w
Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Fri Jul 27 09:28:35 EDT 2007 | rich7799
I have Mpm ap25hie, s/w ver 7.1a The problem I have is that the machine works fine until I teach or use the pre board stop function. As soon as I use this the machine will not load the pcb to the centre of the work nest. I can manually change boardst
Electronics Forum | Wed Jun 02 11:55:11 EDT 2004 | Rob
The way I understand it, Y boardstop is the edge of the board to and from your standpoint not left to right. And as I mention, the best vision is always fiducials not pads. I've worked with those before and I've always had problems when using a pad.
Electronics Forum | Mon Jul 30 17:32:34 EDT 2007 | chrisgriffin
When you teach the "teach boardstop Y" make sure the camera is seeing the leading edge of the board and not too close to the rails. It should calculate the pre-stop position correctly. I assume you have thoroughly checked the sensor. Also check th
Electronics Forum | Tue Jun 01 18:06:36 EDT 2004 | Rob
I used an Ultraprint 2000 so if that's what you use then maybe I might be able to help. First, I'm assuming that you've already passed the Teach New Board section. This is board dimension, X and Y boardstop, stencil/squeegee heights and strokes. If
Electronics Forum | Fri Jan 04 10:39:37 EST 2013 | dontfeedphils
We've got used MPM Accuflex that we recently purchased and it seems like the stencil to board offsets need to be calibrated. After looking into the manual it looks like it requires a fixture or calibration jig, can anyone confirm this? Does anyone
Electronics Forum | Sat Apr 09 21:44:07 EDT 2005 | Marcel
Go in dos, go in the CONFIG dir. Edit the file ACCES.000 Yours passwords are there. You can delete the file and reboot, that will reset all passwords to factory default Operator MPM1 Maintenance MPM2 Supervisor MPM3 Calibrate MPM4 M
