Electronics Forum | Wed Dec 06 23:54:24 EST 2006 | valuems
Think you will find every mpm is operating on dos base software, just in the last 2 years have they got software with windows base. The mouse is related to the version of software, and the old software requires only one model of mouse. Give up tryi
Electronics Forum | Wed Dec 28 11:05:27 EST 2022 | atpico
We have 7.2E (MS-DOS variant) software version on our printer and there are some annoying bugs and less than optimal NPI process (when the new board need to be put on and put off the rails several times during NPI teaching). Is there a known newer/be
Electronics Forum | Wed Jul 21 01:27:17 EDT 2004 | simmcircuits
Hi, I need help in aligning the stencil and the board on an MPM AP25. I have no calib jig and stencil what I did was edit w/dos editor the file ap.cal. It seems to be working OK now just a little bit of offset but what I'm concerned is the software t
Electronics Forum | Mon Jul 30 17:32:34 EDT 2007 | chrisgriffin
When you teach the "teach boardstop Y" make sure the camera is seeing the leading edge of the board and not too close to the rails. It should calculate the pre-stop position correctly. I assume you have thoroughly checked the sensor. Also check th
Electronics Forum | Tue Jul 13 14:03:33 EDT 1999 | Earl Moon
| We are looking to automate the paste printing portion of our SMT process. We are looking at used equipment from DEK and MPM from 1994 onward.(DEK 260 & 265 MPM AP20 & AP27) Does anyone have some feedback or concerns with any of these machines? Does
Electronics Forum | Tue Dec 27 09:39:36 EST 2016 | westshoredesign
Thank you for the reply, MPMEng. I received the Speedline UPG-026/27, but it actually came with the incorrect mouse. Since original post I've contacted seller, received correct mouse, successfully installed drivers, encountered a new issue. At thi
| 1 |
