Electronics Forum | Thu Jul 02 17:06:39 EDT 2015 | aemery
Just to clarify, you are talking about the inner black box not driving down and not the pneumatic function that brings the tactile assembly closer to the stencil? Sometimes the pneumatic shafts get slightly bent and the assembly will not retract. T
Electronics Forum | Fri Jun 12 14:19:03 EDT 2015 | tdemon69
i have a up 3000 ultraflex. the lower half of the tactile sensor is stuck down. i have replaced the driver board, check wire down to drive board,check the fuse for power on the driver board.
Electronics Forum | Sat Jun 13 13:51:44 EDT 2015 | tnisbet
The problem could be the tactile motor, we have it in stock. Please contact sales@goppm.com and request a quote for part number CA-399.
Electronics Forum | Thu Oct 20 10:29:45 EDT 2011 | babe7362000
Can anyone tell me what a Tactile 12-Hardware Limit Warning is on the MPM Up2500? I tried to reset the machine and it gets stuck on the Tactile. If anyone can help, I would appreciate it. Thanks
Electronics Forum | Tue Aug 04 09:02:34 EDT 2009 | kpm135
We replaced the tactile sensor's linear actuator on a MPM Ultraprint 2000 HiE. Now we are getting a Tactile Hardware limit error every time we try to find the stencil height. I was hoping some one could explain why we're getting this error and any i
Electronics Forum | Tue Oct 26 19:56:54 EDT 2004 | Von S
The Tactile Driver old part # is P3746 and MPM changed it to new part # 1012927
Electronics Forum | Thu Oct 20 13:34:08 EDT 2011 | babe7362000
I checked the housing and it can move up and down freely. I went into Cal and also moved it without a problem. The sensors in the digital I/O seem to be fine. I checked the voltage going to the driver card and it seems to be fine. I think I will s
Electronics Forum | Tue Aug 04 13:44:05 EDT 2009 | swag
Check your DIP switch settings on new driver. Not sure about calibration. Try QMPM for password.
Electronics Forum | Tue Aug 04 14:43:12 EDT 2009 | kpm135
Thank you very much SWAG that password did the trick. Got us into the calibration menu and we were able to calibrate the z-axis and snugger height and got it to work. Thanks again
Electronics Forum | Tue Aug 04 10:19:38 EDT 2009 | swag
Here's a few ideas: If it has one, make sure the flexible coupler set screws are tight. Replace the tactile switch (often these appear to work fine in I/O but do not work properly in production). Clean and oil the tactile plunger if it has one. M