Electronics Forum | Wed Jan 31 13:00:43 EST 2007 | bvdb
The continuing saga - we got the IP-1 communicating with the MCS16 again by replacing a couple of chips on the VME1152 CPU board and now it's working again but have a new problem. The machine stops about every other time when changing nozzles with a
Electronics Forum | Wed Jan 31 14:58:13 EST 2007 | pr
Is it the same nozzle every time? I would check that the shaft is hitting dead center (it could be binding)on the nozzles (especially if it only happens on 1 nozzle). Also check the rollers on the shaft (that hold the nozzle) and make sure they line
Electronics Forum | Thu Feb 01 02:36:40 EST 2007 | bvdb
Hi pr, The problem was happening on all three of the nozzles that we were using, about half the time the Z axis would rise up and go for the next nozzle and the other half it would stop almost as soon as it released the nozzle. When I inch the Z ax
Electronics Forum | Thu Oct 13 14:09:44 EDT 2005 | rcanten
If there is no option to send the proper data to the MTU it sounds like your line editor is configured incorrectly. You will still be able to send programs and the such but like you said you would never notice it until you had to send the proper back
Electronics Forum | Wed Oct 12 22:22:31 EDT 2005 | zl3vlf
Hi all! Well installing the servo card has fixed the status LED issue....however there is a new problem :( When a production program is executed at the IP3 (pressing AUTO or START) the machine says 'communicating with the VP' (which is normal). Wh
Electronics Forum | Fri Jul 19 12:58:46 EDT 2013 | markhoch
The wonders of Google... Hope this helps. http://www.winsmt.com/down/001.pdf
Electronics Forum | Fri Jul 19 10:45:55 EDT 2013 | kdc45
Have a Fuji IP-2 and the MTU has a servo alarm. There are three servo amp cards and the middle card is showing a 1 on the LED display. Does anyone know what this indicates? Also, can you tell me which axis this card is for? We do not have an advanced
Electronics Forum | Fri Jul 19 13:50:29 EDT 2013 | kdc45
Thanks for the link, however, I have this manual already and it only shows how to replace motors, belts and prox switches and to adjust for zero set. Appreciate your time and efforts. I did find that it is an OC alarm. Thanks again. Regards, kdc45
Electronics Forum | Fri Oct 15 16:52:52 EDT 2010 | wingding
Fuji IP2: I am having problems with an MTU Cycle Alarm error. There is no such error listed in the IP2 manual or the MTU manual. It sometimes comes up while placing parts on a board or sometimes right after Zero Set. Does anyone know what generates t
Electronics Forum | Fri Sep 16 15:17:08 EDT 2005 | vikkaraja
Most likely servo amp is bad.
.gif)
