Electronics Forum | Thu Mar 05 17:28:37 EST 2020 | sportsradar
I am desperate. I have an 80S15 with a single line controller that we program with and control our 80S15 machine. Everything has been working great until last month. We have not done any changes, and no new programs or jobs. We went to start the PC
Electronics Forum | Fri Sep 03 00:17:21 EDT 1999 | JAX
You use MCS computers to transmit programs/data to machines | | --> MCSs are getting old, so you would like to use F4G or FujiCam just because you could use a standard 486/Pentium | | --> But you still like your current programming SW (obviously not
Electronics Forum | Thu Sep 02 16:55:04 EDT 1999 | Brian
You use MCS computers to transmit programs/data to machines | --> MCSs are getting old, so you would like to use F4G or FujiCam just because you could use a standard 486/Pentium | --> But you still like your current programming SW (obviously not MCS/
Electronics Forum | Wed Sep 25 15:58:36 EDT 2002 | bschreiber
Hello Dave, I hope that electronic slap didn�t hurt too much. Robf, I am sorry that you did not agree with my initial response, but the answer is very detailed and most of the support material I have is only in paper format so I need to either snai
Electronics Forum | Tue Sep 17 12:38:17 EDT 2002 | stepheno
If you have a newer style MPA like the MPA-G3, check out http://www.hoverdavis.com/Products/mpp/mpp.htm I find them much better than the panasonic feeders. You may have to set pitch to 2 or 3 because of timeing issues, or you can change the NC progr
Electronics Forum | Thu Jul 11 14:02:03 EDT 2002 | lysik
Tey will support it but it is like pulling teeth. Do you service MyData machines?
Electronics Forum | Sun Jan 29 11:54:06 EST 2006 | johnw
Hi Dax you want to run a cal card with good cad data on all machines then take the results and then alter the placement xy data to pull all machines into calibration. But make sure all the cameras are calibrated and the pam results are good and withi
Electronics Forum | Wed Aug 15 16:08:02 EDT 2001 | davef
A properly formed solder connection is stronger than the underlying copper to laminate bond. Measuring pad peal strength: IPC-TM-650, Method 2.4.21 for multiple solderings, use Method 2.4.8 for copper peal using an Instron machine. Typical requiremen
Electronics Forum | Sat Mar 17 14:29:28 EDT 2018 | jacobidiego
Hi Experts, Would you point me into the right direction? I am looking a way to download data from smt machinery to avoid having to the in-situ machine's panel, and as we have mixed brands in multiple lines, it gets very hard to analize data. Is the
Electronics Forum | Tue Nov 01 14:38:45 EDT 2022 | glasscake
Did the tray changer use to work on this machine? was it ever disabled and uncoupled from the machine? If you have an old data disk or backup disk of the machine try restoring to that. There is also a jumper inside the wiring harness to include the
winsouce.jpg)
