Electronics Forum | Mon Jul 18 08:57:31 EDT 2005 | tommyttr
It is either the axis card, or the head bd. reporting corrupted data
Electronics Forum | Mon Jul 18 07:11:37 EDT 2005 | geb
Does anyone know what an "Axis Head 1 Theta DAC limit error during Move Absolute Command" may mean? It occurred during production. I have checked through the board's program for errors but cannot see any.
Electronics Forum | Mon Jul 18 10:40:09 EDT 2005 | geb
Thanks for your help. Solved it - The spindles on the head were stiffer than the other heads, so greasing it fixed it.
Electronics Forum | Thu Aug 04 09:40:12 EDT 2022 | jojoled
Hi, did anybody face such error(attached)? After calibrate all axis I get this error. "E202074 : Z axis of left head : SERVO alarm. Turn off the power to the machine and perform inspection" - see attachement. Machine was fully working day
Electronics Forum | Fri Sep 24 16:01:07 EDT 2010 | dougt
I remember this problem but can't remember exactly what the reason was. It might have been the wrong pullup resistor on the MEI interface board used for the home photo on the y axis. You are right, after a couple hours the machine would work fine.
Electronics Forum | Tue Sep 14 07:44:16 EDT 2021 | bukas
hi James. does this happen with every head or just Z6? Does the head move vertically at all? What ANC holder is selected in setup "Hole position detail"? There should be 4 options for "ANC hole position version". If the machine is CP45FV NEO then ANC
Electronics Forum | Thu Mar 07 03:32:32 EST 2013 | benreben
Hi, Can you move the X2 axis manually? if you move head manually(twice) can you see the pulse incremented in the servo menu in IP? with servo just have some parts can defects: -servo it self -servo board -encoder on head
Electronics Forum | Mon Sep 13 20:30:43 EDT 2021 | jamesatqkits
Hello all, thank you to the people that have been helping me out, Hristo and Bukas. I just thought I should put this out there and see if any one can help. When I try to pick up a nozzle I get the following error: [0800] <EMER&gt
Electronics Forum | Tue Sep 14 13:01:11 EDT 2021 | jamesatqkits
Hi Bukas, Every head, yes they move down, I should have mentioned the sensor is on the right , not the left. It detects the mirror swinging down. There is another sensor on the servo motor, its mirror home, it works I see it changing when I break the
Electronics Forum | Mon Feb 04 11:01:44 EST 2013 | bobpan
The way its supposed to work...is....when you do a function 30 the z axis should step down until the nozzle tip is seen in the quad align or laser align. The readout should have a nozzle height but if its the earlier firmware for the machine it might
