Electronics Forum | Tue Dec 21 16:59:59 EST 2021 | tey422
You should able to log into the TPsys to disable the hydra head. BTW, last time I work on the Mydata machine was about 15years ago.
Electronics Forum | Tue Dec 21 12:28:11 EST 2021 | vtdivtecs
hey all, I had a comically bad failure yesterday while working with my pick and place, a part got dropped at exactly the wrong moment and flung a bracket up into the tool path, severely damaging the hydra controlboard that is next to the x camera. T
Electronics Forum | Tue Dec 21 17:15:49 EST 2021 | vtdivtecs
yeap I was able to figure it out and avoid my head being on a stick anywhere. if you log out of tpsys and into hw config you can turn off the hydra head there, then unplug the hardware and the machine will run. if you just disable it inside tpsys t
Electronics Forum | Tue Jun 08 22:30:05 EDT 2021 | vtdivtecs
So I am having a little trouble with my mydata MY19. its an older machine picked up used and its had its quirks. recently we tried to start adding electrical verification to our workflow, and had to disable it as we were getting intermittent bad pa
Electronics Forum | Wed Jan 23 20:01:20 EST 2019 | padawanlinuxero
Hello Sounds to me that the problem might be with vaccum and lot of it, after the component is place theres a small amount of air that pushes the component away from the nozzle in MYDATA we call it a kiss in my facility, have you check that the air
Electronics Forum | Wed Sep 21 12:12:24 EDT 2005 | vikkaraja
HI there, I have a problem with my TP11 HYDRA HEAD. It is not picking up parts from the magazine. I have been working with Mydata on this issue, but I have not had much success so far. So far I done the followings:ran vaccum test, tube height, and H
Electronics Forum | Tue Nov 20 15:03:37 EST 2012 | jaimebc
Bruce, Since we had spares, I replaced the X wagon cables, XFMB cable, nothing. FFX Cable, nothing. Swapped mot cards, nothing. Vaccum seal, nothing.At this point I truly believe the problem is either on the theta encoder or the theta motor. Unfortu
Electronics Forum | Sat May 29 14:03:18 EDT 2010 | padawanlinuxero
Hello guys! I have a problem I had to change the MI Board on a MYDATA TP9-4 machine because it was firing 3 or more feeders at the same time, after the change it run great but then for some reason after a while it start to show an error message that
Electronics Forum | Fri Oct 07 07:43:40 EDT 2005 | cyber_wolf
I am curious to hear what kinds of experiences you Mydata users have had with Mydata technical support... Good?...Bad?...Impartial?..
Electronics Forum | Wed Jul 18 07:48:12 EDT 2007 | cyber_wolf
Bad small X motor most likely. Other possibilities: Bad cables Bad Card
.png)
