Electronics Forum | Thu Jan 26 12:41:07 EST 2017 | bk
It also could be that your user level that you are logged in on may not have access to change parameters
Electronics Forum | Mon Jan 30 03:04:35 EST 2017 | .net
exit TPSys and type setPrinter
Electronics Forum | Tue Jan 24 20:05:24 EST 2017 | erici
we have one dot matrix printer and i would like to connect it to the TP9 machine. The parameters settings for printer is "protected" so i cannot assign the printere to the machine. How do i "unprotect" the parameter to allow me to make changes?
Electronics Forum | Thu Jan 26 11:34:47 EST 2017 | rgduval
If you're lucky, that parameter can be unlocked using the parameters password. If you're unlucky, and it can't be changed using the password, that'll mean it's hardware protected. You'll need a new magic word from Mycronic to update it. Cheers, ..
Electronics Forum | Wed Mar 07 20:37:38 EST 2001 | davef
I agree. The bar coded label you use should not be affected by the solder mask of the board. The label should have sharp contrast between the segments of the code to modulate the returned light and allow the reader to discriminate between light and
Electronics Forum | Thu Mar 08 09:38:35 EST 2001 | blnorman
We've been using pre-printed labels on our PCB's for years, with 8 - 10 hours a week down time associated with them. Last October we put a CO2 laser marker on one of our lines. In 6 months we've had a total of 30 minutes down time. We use a 2D b
Electronics Forum | Fri Jan 28 19:26:51 EST 2011 | jlawson
Milara has a combined Stencil printer + jet Printing ??? Print and then jet print areas not printed or top up prints.
Electronics Forum | Tue Mar 13 11:15:43 EDT 2012 | flyingsnow
It looks like our printing is fine. The short issue is caused by the placement. Mydata we used for placement has a global force setup which cannot be changed for individual component.
Electronics Forum | Wed Jul 20 16:51:03 EDT 2005 | pjc
There is a spec I read that states +/- 0.001" (0.025mm) print deposition accuracy and repeatability is more than adequate for 0201-chip printing. I don't think any print studies where done for 01005 chips yet. There are several other factors besides
