Electronics Forum | Wed Aug 04 12:08:16 EDT 1999 | David Lynch
Jim McCarten and Dave F, Jim - How about a little explanation on your PlacePro 7100 comments? I'd like to know what a "typical SMT board" is and how "thruput is cut in half" by assembling it. Is this typical SMT board something that most manufacture
Electronics Forum | Thu Dec 13 10:39:38 EST 2007 | lloyd
Hi Mefunak, I'd say that the vacuum holding circuit is at fault. If the component is picked OK from the feeder ('vacuum check after pickup' is switched on) then the component is being dropped from the head as the gantry moves to the placement positi
Electronics Forum | Wed Aug 04 14:23:06 EDT 1999 | Dave F
| Jim McCarten and Dave F, | | Jim - How about a little explanation on your PlacePro 7100 comments? I'd like to know what a "typical SMT board" is and how "thruput is cut in half" by assembling it. Is this typical SMT board something that most manuf
Electronics Forum | Mon May 31 15:09:56 EDT 1999 | JohnW
| | | | | | | | I have always thought it to be a good practice to wash SMA's with water soluble paste (WS609) soon after reflow. Is there a time limit as to how long a board should sit after reflow before washing said board? For instance; processi
Electronics Forum | Mon May 31 15:10:14 EDT 1999 | JohnW
| | | | | | | | I have always thought it to be a good practice to wash SMA's with water soluble paste (WS609) soon after reflow. Is there a time limit as to how long a board should sit after reflow before washing said board? For instance; processi
Electronics Forum | Fri Apr 11 16:11:32 EDT 2003 | stefwitt
The question new or used was discussed several times. If you start fresh and have no experience with one or the other machine vendor, I would get a new machine, whose supplier has a service tech in driving distance. If you select the used machine pa
Electronics Forum | Wed Aug 25 22:55:59 EDT 2004 | pdeuel
We started placing 0402 with regular feeders and wasted every other part untill we got the correct feeders. The cost for most parts runs less than 1/20 th of a cent. Reels come in quanities of 10,000 instead of 5,000. You will also need the correct t
Electronics Forum | Wed Feb 12 14:14:42 EST 2020 | alvarez94
I am running a MYDATA MY19 machine.the problem is that the first 2 hours after turning on the machine it does not work throwing the following error: "transducers do not agree". After approximately 1 or 2 hours the machine starts working normally. T
Electronics Forum | Thu Aug 12 16:16:13 EDT 2010 | markgray
I just sold my 3AVX 3 months ago. I machine with feeders is worth $5-10k depending on condition. There are limitations to a 3AVX, mainly dificulty consistantly placing 0603's and not being able to place anything smaller. You might be better off buyin
Electronics Forum | Wed Feb 12 15:11:29 EST 2020 | alvarez94
I was consulting the manual of the machine and to measure the tension of the x belt I need a frequency counter and two prisms but I don't have these tools, is there any other way to measure the tension?