Electronics Forum | Sun Dec 04 16:40:32 EST 2011 | andersenequipment
I am replacing a hard drive on a mydata tp11. it ask me for a passcode??? does anyone know how to clear this out? it has the original stuff in it. Please advise.. Tom
Electronics Forum | Sun Dec 04 16:54:52 EST 2011 | andersenequipment
I have a mydata tp-11, crap hard drive, When I look to replace the hard drive with another, the machine ask me for a password or passcode. Anyone help?
Electronics Forum | Wed Dec 14 11:35:32 EST 2011 | eezday
I have had this problem and I've resolved it. I don't have access to the PW at this moment but I've requested it be sent to me. Please don't give up on this thread. Try these passwords: "anders" and "akuankka"
Electronics Forum | Mon Dec 19 15:56:12 EST 2011 | armandogomez
Hi! I have 2 Mydatas in here, I think the 2 passwords are not the ones you are looking for, Might be that the software is looking for something call the Magic Word? if so, you need to contact MYDATA so that they can send you the "Magic Word", you se
Electronics Forum | Thu Jan 26 11:34:47 EST 2017 | rgduval
If you're lucky, that parameter can be unlocked using the parameters password. If you're unlucky, and it can't be changed using the password, that'll mean it's hardware protected. You'll need a new magic word from Mycronic to update it. Cheers, ..
Electronics Forum | Mon Apr 04 12:58:50 EDT 2005 | Roger @ Tyco [Formally Quad]
Passwords for the ZCR / QCR did change with the version of S/W. I believe that from version 2.9 onwards the password to start the S/W from the DOS prompt is "quad" [all lower case]. Pre version 2.9 please type "zcr" [All lower case]. This will enable
Electronics Forum | Sat Apr 09 23:14:36 EDT 2005 | MikeaJ
In response to the post concerning the UP1500, the case is a little different. The Speedline/SMTech passwords are hardcoded into the Sigpro.exe file. Here is what you need to know: Login name: Speedline (or SMTech) Passwords are listed in order of ri
Electronics Forum | Tue Jan 24 20:05:24 EST 2017 | erici
we have one dot matrix printer and i would like to connect it to the TP9 machine. The parameters settings for printer is "protected" so i cannot assign the printere to the machine. How do i "unprotect" the parameter to allow me to make changes?
Electronics Forum | Thu Jan 26 12:41:07 EST 2017 | bk
It also could be that your user level that you are logged in on may not have access to change parameters
Electronics Forum | Tue Apr 03 08:01:21 EDT 2018 | gfe
Hello Bobpan, Thank you very much for replying, Actually there is the utility of Axis speed, but it asks for a password that I do not have, compliments.
winsouce.jpg)
