Electronics Forum | Wed Dec 14 11:35:32 EST 2011 | eezday
I have had this problem and I've resolved it. I don't have access to the PW at this moment but I've requested it be sent to me. Please don't give up on this thread. Try these passwords: "anders" and "akuankka"
Electronics Forum | Mon Nov 12 12:00:59 EST 2007 | wayne123
A philips Topaz is a good machine, I have accurately placed 0402's without a problem, Fine pitch QFP no problem, BGA's not a problem, I am not familiar with the TP9 so hopefully the other guy can answere questions on that, The Topaz is rated at about
Electronics Forum | Fri May 07 01:50:28 EDT 2010 | tonaxel
Hello, I just have a bit problems with one TM8 what is not always able to put the parts in the right pick position. The wheel with the part stops very often before the pick position. Does anybody have a service manual for the TM8? Thank you very muc
Electronics Forum | Fri May 07 13:28:13 EDT 2010 | tonaxel
Hello SR.Tech, yes, the general positions from 1 to 16 are ok. I also changed the pressure of the spring what is on the achsis for the tape transport wheels. This helped a lot for the most wheels but not for all. I will try it again. Maybee the pres
Electronics Forum | Thu Feb 13 09:52:03 EST 2014 | rgduval
Start by getting into the maintenance menu, and manually installing the Servo program for all MOTs. If they install fine, you can check the Z-motor while you're in the maintenance menus. Make sure that the z-locks are unlocked before checking the
Electronics Forum | Sun Aug 21 15:40:35 EDT 2011 | padawanlinuxero
Hi I had the same problem but with a MY12, and I have to say that we search for it but we did not find something, my guess you can talk to MYDATA to RUSH delivery from sweden o norway somewhere up there.
Electronics Forum | Wed Jun 09 23:58:59 EDT 2021 | SMTA-64387687
The electrical test, on those older machines, wasn't very exact. Try to expand the tolerances, 25-30% for caps and 10% for resistors, and see if that solves your problem. Also, if I remember correctly, if you go into the layout and single-place the c
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
WINTECH provides new/used/pre-owned SMT, AI & PCB Assembly (PCBA) equipment of various brands. Also supply service, modification & original or local-made spare parts. We are also an appointed agent for well-known brands.
Equipment Dealer / Broker / Auctions
NO. 1 LORONG SAGA JAYA 6
PERAI, 09 Malaysia
Phone: 6043809899
