Electronics Forum | Thu Feb 10 14:56:50 EST 2005 | jimdugan
The Mydata machine is a very good high mix low volume machine. If you buy from Mydata you will be better supported, than if you buy from a broker. I would recommend you buy the newer My series machine. The TP machine was a good machine but the My ma
Electronics Forum | Fri Feb 11 15:50:51 EST 2005 | Grant
Hi, We are looking at selling the machine in mid April, May time frame. We are selling the machine, all feeders etc. But it's located in Australia, so a bit hard to ship to most locations. If your interested, please email grantpetty@blackmagic-desig
Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
Electronics Forum | Mon Nov 12 13:35:34 EST 2007 | dyoungquist
MyData TP9s Work well in high mix applications because change over time from 1 job to the next can be done in as little as 15 minutes if you have the right mix of magazines/feeders. Component placement rates vary depending on which component you ar
Electronics Forum | Mon Nov 12 12:00:59 EST 2007 | wayne123
A philips Topaz is a good machine, I have accurately placed 0402's without a problem, Fine pitch QFP no problem, BGA's not a problem, I am not familiar with the TP9 so hopefully the other guy can answere questions on that, The Topaz is rated at about
Electronics Forum | Wed Apr 15 13:03:14 EDT 2009 | toddscherrsymcomcom
I am looking for any input on the linear stick feeder from Mydata. We currently use a vibe feeder and have a high number of miss picks/rejects on SO8 packages. Is the linear stick feeder worth the investment to upgrade from vibe?
Electronics Forum | Wed Nov 24 11:06:50 EST 2004 | ccleland
You might want to look into one of the machines from Europlacer or Mydata that have very high feeder capacities(200 or more) and intelligent feeders. They were designed for minimal change over time in high mix environments.
Electronics Forum | Fri Oct 01 00:49:33 EDT 2010 | darrenj
Yes, we have the Agilis stick feeder and it is a definite improvement on the vibe. It usually comes with a set of starter 'tubeforks', but i bought another starter set after a while since the individual tubeforks are relatively expenisive. Always g
Electronics Forum | Sat Nov 20 04:32:45 EST 2021 | smtusa
Will TM series feeders (from a TP-11) run slow on a MY series machines with HYDRA head? Are there any MY series machines with dual HYDRA heads?
Electronics Forum | Sat Nov 20 12:10:37 EST 2021 | bk
Yes, you can run tm magazines on my machines but with the hydra heads they are not quite as accurate and miss pick more parts then agilis feeders. Mycronics does sell dual head machines with 2 midas heads and 2 sets of hydras
winsouce.jpg)
