Electronics Forum | Thu Feb 14 17:00:42 EST 2013 | richardc
I am trying to use Mydata TM8C feeders that work fine on a TP93 running 1.6.18 TPsys but are not recognized by a TP94 machine running 1.4.7 TPsys. I get a green flashing light instead of a solid green. I can initialize the hardware but can not proc
Electronics Forum | Thu Feb 14 23:32:50 EST 2013 | padawanlinuxero
Hello ! I don't know if this helps but here goes, I have here 2 mydatas one a TP9-4 and the other MY12, on the TP9-4 we have TPSys 2.4 and we use a AM8 feeder magazine, when we bought the MY12 it came with TPSys 2.1, thinking we can use the AM8 feede
Electronics Forum | Thu Feb 10 14:56:50 EST 2005 | jimdugan
The Mydata machine is a very good high mix low volume machine. If you buy from Mydata you will be better supported, than if you buy from a broker. I would recommend you buy the newer My series machine. The TP machine was a good machine but the My ma
Electronics Forum | Fri Feb 11 15:50:51 EST 2005 | Grant
Hi, We are looking at selling the machine in mid April, May time frame. We are selling the machine, all feeders etc. But it's located in Australia, so a bit hard to ship to most locations. If your interested, please email grantpetty@blackmagic-desig
Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
Electronics Forum | Mon Feb 02 08:57:26 EST 2004 | pjc
Contact Mydata and they can give you a lengthly list of Agilis users to contact.
Electronics Forum | Tue Jan 27 10:12:21 EST 2004 | ldavis
Has anyone completed time studies on Mydata's Agilis feeder system? Is the time to load / unload reels any faster than traditional feeders? Any comments regarding the Agilis feeders would be greatly appreciated.
Electronics Forum | Mon Nov 12 13:35:34 EST 2007 | dyoungquist
MyData TP9s Work well in high mix applications because change over time from 1 job to the next can be done in as little as 15 minutes if you have the right mix of magazines/feeders. Component placement rates vary depending on which component you ar
Electronics Forum | Mon Nov 12 12:00:59 EST 2007 | wayne123
A philips Topaz is a good machine, I have accurately placed 0402's without a problem, Fine pitch QFP no problem, BGA's not a problem, I am not familiar with the TP9 so hopefully the other guy can answere questions on that, The Topaz is rated at about
Electronics Forum | Fri Feb 15 08:37:44 EST 2013 | cyber_wolf
I think your MOT cards have to get upgraded too.
