Electronics Forum | Mon Nov 19 13:35:25 EST 2007 | cyber_wolf
Be aware that there is a significant difference between TP9 2U's and TP9 UFP's.
Electronics Forum | Tue May 07 12:30:30 EDT 2013 | shankar2013
We are having a problem with our Mydata TP9-2U where the machine shuts down during a job with this message seen on the service monitor -- F-MOT1-26/156:MOVFI: MOTOR TIMEOUT Has anybody seen this problem?
Electronics Forum | Wed Aug 21 06:19:17 EDT 2019 | mxtimra
Mydata TP9-2U gives error code MOT1-38/186:MSETDYNX What is that code ? Machine give that code and wont make start up process. Appreciate if someone has knowledge that code, thanks.
Electronics Forum | Tue May 07 14:54:38 EDT 2013 | shankar2013
Tried High and highest. Same message on shut down
Electronics Forum | Mon Nov 14 12:11:20 EST 2005 | binhanhaokiet
We just bought a used TP9-2U, I could not do a W-wagon camera calibrate. It keep saying "Calibrate failed, can't located all point", I do not know what should I do next. I did refocus the camera but it still does not help. Please help
Electronics Forum | Wed Jul 18 06:47:38 EDT 2007 | cyber_wolf
I was asking if it was a TP9 2U...... If you have a UFP machine then you are in luck. It is most likely the small X-motor. You can test it in the service program. Does the X-axis bounce when you are trimming magazines and stepping through placement
Electronics Forum | Mon Nov 14 12:17:17 EST 2005 | avalancher
You should contact MYDATA service department and see what advise their phone support people can offer. You may not be doing the process correctly (wrong calibration boards, etc...)
Electronics Forum | Wed May 29 10:05:59 EDT 2013 | Adrian
Hi , we have one unit of mydata TP9 we want to sell as spare parts machines. Selling as its condition. No feeders. If keen, pls contact me . thanks
Electronics Forum | Tue Nov 15 08:17:05 EST 2005 | cyber_wolf
What are you trying to calibrate? I think you mis-typed...there is no W-wagon. I think you meant X-wagon camera. I have never seen one of these go out of cal. Why do you think it needs calibrated ?
Electronics Forum | Tue Feb 20 20:07:33 EST 2007 | mdang
My machine TP9-2U have the same problem. I use the camera to walk through the program and it is off and not repeatable. I think the machine has backlash but I don't know how to tighten it up. Can you help??? Thanks, -Michael
