Electronics Forum | Wed May 16 00:14:45 EDT 2018 | leeg
We have a Dek Horizon and we have started getting a data file open error when trying to save files. This is resulting in us having to re-teach board fiducials etc in every time we switch back to a previous job. Any ideas?
Electronics Forum | Wed Nov 07 14:24:50 EST 2018 | babe7362000
Is there a calibration file that saves on the Yestech after a Calibration is complete? and If so where is that located? Thanks
Electronics Forum | Fri Sep 01 15:52:03 EDT 2017 | wyluliwolf
Long story short: I paid someone to convert some older Gerber files to the new RS-274x format for me so I could have them manufactured. I sent them the original Gerber files (RS-274D) along with additional files showing information on the layout. T
Electronics Forum | Mon Sep 20 09:02:34 EDT 1999 | Wolfgang Busko
| Hi all, | | We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we need your advice. | | We are producing VGA cards and mother boards for PC's all components to be wave soldered are TH, the S
Electronics Forum | Tue Sep 21 02:51:06 EDT 1999 | Mohammed saad
Thank you all for your help. about your question Wolfgang, I am using no-clean solder paste from Kester. Mohammed | | Hi all, | | | | We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we ne
Electronics Forum | Tue May 15 04:15:36 EDT 2018 | godless
After reinstalling software, i get message when loading printer: "A printer file could not be opened, therefore the printer cannot be started. Please inster your calibration diskette and press confirm. or contact or contact DEK customer support. Pres
Electronics Forum | Mon Feb 06 14:27:19 EST 2017 | saunders415
Hello, I am attempting to find the location of information packages for electronic components of the RC software that is used for the europlacer. Does anyone know where RC saves the component packages? I looked in the EUROPLACER/ep/bib yet it was no
Electronics Forum | Mon Nov 20 13:53:13 EST 2023 | carl_p
I would ensure a nozzle is fitted to spindle 1, UIC genesis, Fuzion etc can be a bit funny with this. If that checks out ok, I would be ensuring nothing is obstructing the Z travel. Next would be to ensure the Z motor is at home & again this is wor
Electronics Forum | Tue Sep 20 13:36:47 EDT 2016 | davef
ATTACHMENTS => CHOOSE FILE =>[select a save file / OPEN] => ADD => OK=> POST
Electronics Forum | Thu Jun 23 14:07:14 EDT 2005 | dutch69
Your MPM memory evidently full.When you save file sure that is saved correctly .Always save file during printer work .