Electronics Forum | Fri Jun 23 12:54:53 EDT 2017 | guts1872
We are having issues with top fill and dropping pins on Molex connectors with our KISS 101. Unfortunately we do not have a pre heater and bottom side pre heat with our nozzles is not satisfactory. Most of the issues occur when using a no clean proces
Electronics Forum | Thu Jun 29 12:07:09 EDT 2017 | georgetruitt
HOW THICK IS THE BOARD? IS THERE A LOT OF COPPER IN THE BOARD? DOES YOUR CUSTOMERS PROVIDE HEAT RELIEF IN THE BOARDS BARREL DESIGN THERE NEEDS TO BE PLENTY OF ROOM FOR LEADFREE SOLDER TO FLOW, DID YOU CHECK YOUR PIN(LEAD)TO HOLE (BARREL) RATIO? N
Electronics Forum | Sat Mar 30 13:18:04 EDT 2019 | stephendo
A heat pump pumps heat. The poster was talking about pumping molten solder.
Electronics Forum | Fri Mar 29 06:59:06 EDT 2019 | jacoblemaster
For what purpose you are looking at this electromagnetic pump? I am having a heat pump in my home. I know the bit about this pump but it is hard to maintain it.
Electronics Forum | Mon Sep 20 14:46:03 EDT 1999 | Dave F
| Hi all, | | We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we need your advice. | | We are producing VGA cards and mother boards for PC's all components to be wave soldered are TH, the S
Electronics Forum | Mon Sep 20 17:20:08 EDT 1999 | Earl Moon
| | Hi all, | | | | We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we need your advice. | | | | We are producing VGA cards and mother boards for PC's all components to be wave soldered are
Electronics Forum | Mon Sep 20 17:36:46 EDT 1999 | Dave F
| | | Hi all, | | | | | | We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we need your advice. | | | | | | We are producing VGA cards and mother boards for PC's all components to be wave so
Electronics Forum | Tue Sep 21 07:47:31 EDT 1999 | Wolfgang Busko
| | Hi all, | | | | We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we need your advice. | | | | We are producing VGA cards and mother boards for PC's all components to be wave soldered are
Electronics Forum | Mon Apr 18 12:14:39 EDT 2022 | proceng1
As far as hole fill, as was stated above, class 2 only requires 50% up-fill. In order to get better up-fill on the initial pass, you may need to consider more pre-heat. Also, better application of flux. Are you using a drop jet, or a spray? You
Electronics Forum | Tue Dec 12 17:54:04 EST 2000 | ralph
I've had this problem myself, though in using water soluables. But the process to eliminate it is still the same. There are three possible causes for this to occure. Too much humidity, to much solder, and too much heat. Are you leaving the paste
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
.gif)
winsouce.jpg)