Electronics Forum | Tue Jun 09 04:49:12 EDT 2015 | vinitverma
Is the machine not picking up nozzle from the nozzle changer or is the head 7 not picking up any components? Or is the mis-pick rate too high?
Electronics Forum | Tue May 12 17:01:27 EDT 2015 | lisaaci
Our Philips Topaz is not picking up any nozzles on head 7, or only partially picking it up. Previously, the machine had thrown up a message that head/nozzle 7 needed cleaning, but that message doesn't appear anymore. I don't know if the head needs cl
Electronics Forum | Tue Jun 09 09:04:58 EDT 2015 | lisaaci
Its not picking up the nozzle from the changer. It either doesn't at all, or leaves the nozzle partially in the changer.
Electronics Forum | Wed Jun 10 00:34:40 EDT 2015 | vinitverma
I understand from your post that the head does go to the nozzle changer intending to change the nozzle but sometimes it entirely fails to pick up the nozzle and sometimes the nozzle gets picked up a bit but gets stuck in the nozzle changer. This mos
Electronics Forum | Tue Jun 09 14:10:41 EDT 2015 | duchoang
Last time I used Topaz X2 was 5 years ago. Correct me if I'm wrong. There are some reasons: -Head dirty so machine thought there was nozzle on head already. -Nozzle changer/ Nozzle position offset. -Something jammed and nozzle changer can not go all
Electronics Forum | Wed Jun 10 01:33:20 EDT 2015 | leeg
Are the leaf springs in good order and set right? If they are then it could be calibration related.
Electronics Forum | Wed Jun 10 01:35:07 EDT 2015 | leeg
Does head 7 calibrate ok? Is it a bent shaft?
Electronics Forum | Thu Jun 15 22:17:02 EDT 2006 | Thanagon
I'm now have target to flux saving. Could you please tell me. If we adjust level of spray fluxer nozzle up then we can saving cost of flux Quantity usage? What Others must adjust? such as pressure , flux flow. Thank you All for advise.
Electronics Forum | Fri Dec 10 12:25:53 EST 1999 | Marlies Hanf
Hi. Placement machines use nozzles to pick up the components. I found the terms "suction nozzle", "vacuum nozzle" or simply "nozzle". Do the terms all mean the same or is there a difference? Are there also nozzles that don't work with vacuum?
Electronics Forum | Sun Jun 18 21:41:58 EDT 2006 | Thanagon
Dear Sir, We used TAMURA type : TAF30-12DNS. This type nozzle can't moving up and down but we will modify that.Please comment that is O.K.? Regards, Thanagon
