Electronics Forum | Tue Feb 16 16:57:44 EST 2021 | spoiltforchoice
But that only applies fully if you have the nozzles inline head to match, fast turret heads prefer to hammer a single lane, at least that would be my understanding given I don't have one :(. More active reels = more to track, that may matter to some.
Electronics Forum | Thu Nov 03 02:16:55 EDT 2022 | spacecase
Hey I'm having an issue with a samsung 421f component placer. The machine is fine on the first 5 boards then on the 6th or so it just throws them wherever. The problem is the smallest flat components start sticking to the nozzle even after hitting th
Electronics Forum | Tue Dec 16 22:38:51 EST 2008 | ashley
Hello Sr.Tech, Please write direct to apexservice@apexsmt.com I am sure they are able & willing to provide to you sample nozzles for your evaluation. Just let them know the sizes that you need. Apex SMT in Singapore is also be able to support other
Electronics Forum | Wed May 26 10:00:03 EDT 1999 | David Scott
| | | | | | | | | | | | Any suggestions on how to maintain Adhesive dispensing nozzles??? They seem to plug up over night and it is starting to get on my nerves. We have tried leaving the nozzles in the machine, removing them and soaking in alcoh
Electronics Forum | Fri Feb 25 16:34:53 EST 2005 | jimmyb
In your PDs you must specify a single nozzle size. Meaning don't assume that entering nozzle size max=1.3 and nozzle size min=1.3 forces the machine to use a 1.3. Nozzle size min is not used in the CP6 software (it only uses nozzle size max), there
Electronics Forum | Thu Nov 13 13:12:57 EST 2014 | jimmyboz
Are you using MCS1 or MCS2 software on the MCS16? For MCS1 I would have to try and remember, haven't seen that software in 20 years. For MCS2 in the PD make sure nozzle size, nozzle size min, and nozzle size max are all set to Med.
Electronics Forum | Wed Mar 18 22:52:15 EDT 2015 | mdang
What nozzle size do you use to place 01005 on Fuji CP8 machine? The smallest nozzle size on the CP8 is 0.4mm. Could we use this nozzle to place 01005 since the size of 01005 pacakge is 0.4mm x 0.2mm. Thank you for your help, -Michael
Electronics Forum | Wed Oct 12 08:02:31 EDT 2011 | emeto
It looks like a nozzle size issue. Make sure you have the right nozzle size for the part as well as the right feeder.I think that if the machine takes the parts from the feeders, it can't be feeder problem. Usually parts will jump out of the feeder
Electronics Forum | Thu Aug 22 02:18:09 EDT 2002 | mjabure
Specify the nozzle size as 1.4 in both the nozzle allocation table and the PD, the nozzles will still pass center test as the size variation is still within tolerence.
Electronics Forum | Sun Sep 11 02:33:07 EDT 2011 | johndoe0222
We are using Fuji CP iv-3 and keep getting "Nozzle size alarm and Nozzle position error." I was wondering what is wrong and how do I fix these errors? Thanks
