Electronics Forum | Tue Jun 22 13:35:40 EDT 1999 | Jason Gregory
I am need of info regarding the tape cutter blades for a Sanyo/Universal 4760 HSP chipshooter. Ours are gone and beyond repair. I have found that the blades are the same as on the 4765 HSP. Part nos. are UPPER-6300056280 LOWER-6300056273 Please he
Electronics Forum | Tue Jun 22 13:37:56 EDT 1999 | Jason Gregory
| I am need of info regarding the tape cutter blades for a Sanyo/Universal 4760 HSP chipshooter. Ours are gone and beyond repair. I have found that the blades are the same as on the 4765 HSP. Part nos. are | | UPPER-6300056280 | LOWER-6300056273 |
Electronics Forum | Fri Sep 01 19:54:31 EDT 2017 | tmennink
What was the outcome OrHorti after baking some? In the end we went with a different machine (Fuji NXT) which was able to get the leds out of the reel. After switching we still face a loss of about 0.5% but it is acceptable for now.
Electronics Forum | Wed Aug 02 05:27:00 EDT 2017 | tmennink
We did this test, we opened the tape and turned it upside down, indeed some leds were staying inside the tape. We will try placing them next week with a fuji NXT line. We also contacted the manufacturer, apparently heat perhaps during transport coul
Electronics Forum | Fri Jun 16 00:45:19 EDT 2006 | Richard Robins-Bird
Not all splicing tapes require the use of specialist tooling or splicing plates to make a join. Please see wwww.fujismt.com where a complete range of SMT splicing tapes (Joint Tapes) can be found for use with chip mounters such as Assembleon, Europla
Electronics Forum | Wed Sep 21 10:40:18 EDT 2005 | PWH
Splicing for us has been a rough go as we haven't really found a tool that works well/fast. We have a few different machines = different feeders. They all react different to a splicing "style". The best so far is a crimp tool that crimps a brass s
Electronics Forum | Wed Jun 12 19:19:18 EDT 2019 | kewiley
We are designing a solution for the NXT feeder beta testing is a few months out.
Electronics Forum | Mon May 28 22:39:20 EDT 2007 | fazan83
Guys please help. Does anybody know what is the length of the empty components space in tape and reel that we need to provide for the Fuji NXT feeders to enable the FUji NXT placement? Please give me spec for 8mm, 12mm feeders and ETC. ALso if som
Electronics Forum | Mon Mar 05 18:04:43 EST 2007 | stepheniii
If it might go in a clean room you will want to look at if the system cuts the paper tapes. In the old days there was no vacuum at the cutter and around the machine would accumulate white dust from the machine cutting the tape for each component. The
Electronics Forum | Fri Jun 03 09:37:59 EDT 2016 | sumote
Same here. Buy it by the 2-pack at Staples. If the tape does not get used often we pull off about 5 inches and discard before we use it. The exposed tape between the cutter and the roll, and 1 rotation around the outside of the roll attracts dust and
