Electronics Forum | Fri Oct 28 06:59:45 EDT 2005 | Rob
From what I remember there is a "snap off" setting in the AP25, where you can set the separation speed & I think it may also vibrate the board a little.
Electronics Forum | Thu Nov 05 16:38:45 EST 2009 | rdoss
I don't recall where the puff off setting is either, but i know there is one. Find it and use that along with extending your pressing time. This will increase the time in which the nozzle holds the component in the solder. That, along with the puf
Electronics Forum | Mon Apr 09 13:28:06 EDT 2001 | slthomas
I've been wondering if I was the only person thinking this. There are so many print parameters that are programmable now on new machines (squeegee pressure, height, speed, snap-off settings, cleaning intervals) that the process would (in my oh-so-hu
Electronics Forum | Wed Aug 29 19:52:35 EDT 2007 | crashoveride
A ssume that were talking two-lead LEDS with 2.5mm pitch or lead-to-lead distance. Just a question: are the LED terminals shape were Square or the naturally rounded? Due to different insert rotations, you may wish to do program off-sets per rotation
Electronics Forum | Wed Nov 04 10:31:25 EST 2009 | vetteboy86
I'm not familiar with a puff off setting. I have tried some different things including release delay to shut the vacuum off before the nozzle lifts in the upward direction. I tried to minimally overstroke the part hoping the paste tension would over
Electronics Forum | Sat Nov 05 20:04:40 EDT 2016 | sarason
You would be better off setting a new fiducial using a pad or other feature that would serve that purpose. If the board has not etched correctly, it is better to bad mark it and not use that board on a panel. Safer in the long run as it may have othe
Electronics Forum | Tue Jun 20 20:31:12 EDT 2000 | Dave F
Chrys you're fine. On scoring: * Be sure spec material remaining, not what is removed. * Be sure that the v-grooves are perpendicular to each other, not off set. * Typ spec for for .062 thick boards FR-4 0.018-0.024 MC-3 0.030-0.040 * HADCO recomm
Electronics Forum | Fri Jun 22 11:09:01 EDT 2007 | realchunks
Sup G! Normally when spray fluxers get neglected, the spray pattern is the first thing affected. To actually 'see' this, we cut out a piece of cardboard the same size and length of the board. Run it over the fluxer and then turn itover and look at
Electronics Forum | Thu Aug 30 11:02:51 EDT 2007 | gmoritz
... talking two-lead LEDS with 2.5mm pitch ... Yes. That's what we are working with. > are the LED terminals shape were Square or > the naturally rounded? Some are round. Some are square. One is U-shaped. > Due to different insert rotations,
Electronics Forum | Fri Aug 31 16:30:27 EDT 2007 | gmoritz
> > you may wish to do program off-sets per rotation ... I responded: > > You went over my head with that one. ... Steve Thomas helpfully added: > ... can reach that screen with SH SET command, Since I have not yet located a programming manual
.gif)
winsouce.jpg)