Electronics Forum | Thu Sep 07 10:03:30 EDT 2000 | KS Wong
Hello, I am looking for input on the 7 zone convectional reflow oven on the temperature profiling. I having a problem with the flux/solder spattering on the Au cotact fingers. I have ran some experiment with the soak time and reflow time. Anyway,
Electronics Forum | Thu Sep 07 11:02:29 EDT 2000 | Travis Slaughter
Maybe its not splatter, in my experience a sloppy operator can get paste on contacts and just one sphere can rune them and can look like splatter.
Electronics Forum | Fri Sep 08 00:24:35 EDT 2000 | Jim Arnold
Sudden flux boil will cause splatter. More thorough drying or a slower intial ramp to allow drying to occur before a boil or "splatter" temperature is reached may aid your problem.
Electronics Forum | Fri Sep 08 04:45:17 EDT 2000 | PeterB
As per Travis's reply it could be something other than the reflow process. Another good one is if the printed PCB's have been cleaned down due to print misregistration etc.. If not properly controlled paste residues can remain distributed about the p
Electronics Forum | Fri Aug 20 12:41:20 EDT 1999 | stefano bolleri
| | Yesterday as I was creating a profile on a plastic BGA using Conceptronics freedom 2000 rework station, I happend to discover that I was able to remove solder bridging from a plastic BGA. | | | | This is what I did. | | | | Created a removal pr
Electronics Forum | Fri Aug 20 14:51:47 EDT 1999 | Tony
| | | Yesterday as I was creating a profile on a plastic BGA using Conceptronics freedom 2000 rework station, I happend to discover that I was able to remove solder bridging from a plastic BGA. | | | | | | This is what I did. | | | | | | Created a
Electronics Forum | Fri Aug 20 14:51:55 EDT 1999 | Tony
| | | Yesterday as I was creating a profile on a plastic BGA using Conceptronics freedom 2000 rework station, I happend to discover that I was able to remove solder bridging from a plastic BGA. | | | | | | This is what I did. | | | | | | Created a
Electronics Forum | Fri Aug 20 17:17:14 EDT 1999 | K.T
| | | | Yesterday as I was creating a profile on a plastic BGA using Conceptronics freedom 2000 rework station, I happend to discover that I was able to remove solder bridging from a plastic BGA. | | | | | | | | This is what I did. | | | | | | | |
Electronics Forum | Wed Apr 21 02:53:33 EDT 1999 | Raul N.
25 PPM)! | | | | 1. Is there a better process to solder the leads of QFP's with lifted "minute" lifted leads still having a realiable solder joints? | | | | 2. Or has anybody tried modifying solder pads and use thicker solder paste deposit to compe
Electronics Forum | Mon Mar 15 08:06:46 EST 1999 | Ron Lahat
After rmoving a BGA (plastic)to correct unexplained shorts I installed another BGA using flux only. Checking on an X Ray machine and found two shorts. can anyone give a good explenation ? Thanks Ron
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
