Electronics Forum | Sat Sep 08 23:36:14 EDT 2012 | mtech88
Can anyone help me out this Fuji CP4 problem? I just move my machine to a new place, The feeding sensor error keep on poping up. but the mahine work on manual mode. When we switch to auto mode, it just to pick up the part and the machine stop on t
Electronics Forum | Mon Sep 10 12:18:05 EDT 2012 | benreben
Hi, what's the feeding sensor error? the sensor for cartrige or the sensor on cylinder up of feeder? manual is step mode? if you have the number of error at screen,i have the fuji error code help. in step mode the machine is very slowly,maybe the a
Electronics Forum | Mon Apr 29 12:35:13 EDT 2024 | radek
Fuse was ok but the resistor which feed optocoupler was burned out. After replacing resistor everything is working fine. Now I've got error: "Infeed disbaled" - but this is configuration error ? BTW I have one more question - can I use this machine
Electronics Forum | Tue Mar 01 10:43:59 EST 2005 | Rob
Hi Greg, Is anyone logging the errors at QC/touch up stage so they can feed them straight back to SMT and fix them? (i.e. skipped components, poor paste coverage etc) Obviously the faster you spot an error the cheaper it will be for you. Cheers,
Electronics Forum | Thu Jan 05 23:49:12 EST 2017 | anhsang38
Dear All I'm having proplem with a component(resister). it was over turned after feeding,Depending the reel component so the mounter will be error when picking. i have already check feeder, it is ok. I'm suspecting the reel component was been esd.
Electronics Forum | Thu Aug 12 17:03:44 EDT 1999 | Brian Wycoff
| | Q.C. manager asking me about spc's for Mydata Pick & Place. | | Other then Visual inspection, is there other ways to automate | | placement inspction? | | | | Thanks | | | Sure! There are a few automated vision systems available today that co
Electronics Forum | Thu Jul 09 13:19:38 EDT 2009 | emanuel
Just in case somebody will bump in the same situation and looks for a possible solution, the problem was with a small 2 pin connector that feeds one of the W DC motors. The connector looked ok, but one of the pins pulled a little out and was making
Electronics Forum | Wed Sep 12 11:52:31 EDT 2012 | mtech88
Ben: you are right, I think the timing must be off some how. I will check the error code and post it back here. thanks David
Electronics Forum | Tue Jul 31 22:32:35 EDT 2018 | dekhead
Hardware dongle on back of machine is software key which may or may not be required for your software (depends on software version) and has nothing to do with the error you are experiencing. The hardware link to which I refer is on the Y1 backplane
Electronics Forum | Mon Mar 04 13:48:53 EST 2013 | orlando216
Greetings to all, I have the following problem with an IP-3 from Fuji, At display is says: Cannot Move: X1 Axis Feeding aborted Servo Alarm X2 AXIS Servo Ove
.gif)
winsouce.jpg)