Electronics Forum | Fri Jan 11 06:38:58 EST 2019 | tirthkar8980
what is the standard for pad size of SMD chip type components
Electronics Forum | Sat Jan 12 01:25:53 EST 2019 | tirthkar8980
Respected sir, thank you so for useful information. Thank you, Tirthkar
Electronics Forum | Fri Jan 11 14:45:03 EST 2019 | davef
Here's a presentation on IPC-7351C [ http://www.ocipcdc.org/archive/What_is_New_in_IPC-7351C_03_11_2015.pdf ] by Tom Hausherr, CEO & Founder of PCB Libraries, Inc. PCB Libraries helps support SMTnet.com
Electronics Forum | Thu Jun 29 09:12:27 EDT 2000 | sree
What is the best aperture opening for micrBGA with 0.8 mm ball pitch and 16 mils ball diameter?The pad size on the PCB is 12 mils.
Electronics Forum | Fri Jun 30 10:42:24 EDT 2000 | Chrys Shea
That pad had a 16 mil dia, so I arrived at 20 mil squares by adding 2 mils to each side of the pad. Following that logic, a 12 mil pad would use a 16 mil square. But a 12 mil pad is on a finer pitch that isn't mentioned, so you should definitely
Electronics Forum | Thu Jun 29 09:46:41 EDT 2000 | sree
Hi Jax, The microbga discussed earlier in the forum is mounted on 16 mils pad whereas mine is on 12 mils pad. Can I use the same aperture opening ?Please advise.
Electronics Forum | Thu Jun 29 11:52:23 EDT 2000 | JAX
sree, There is no Definite. You have to make the call. If you think the previous info was on target, use the info provided to find out the appropriate percentage relation between ball diameter, pad diameter, and aperture size. If you already run BGA,
Electronics Forum | Thu Jun 29 09:29:46 EDT 2000 | JAX
sree, You might want to check the archives. If not, I found this just a few questions below yours!! [Back to thread listing at top] Posted by Igmar on June 22, 2000 at 10:27:26 AM EST Can someone please help with the aperture size on a Micro BGA st
Electronics Forum | Mon Oct 03 05:10:19 EDT 2016 | robl
Hi Nikhilesh, It was a long time ago, but we used to buy the nickel in reels then had a cut and feed station on the smt machine with selectable sizes. We did many types of boards in very large volumes, and usually the Nickel strip was soldered to t
Electronics Forum | Thu Jun 22 10:27:26 EDT 2000 | Igmar
Can someone please help with the aperture size on a Micro BGA stencil. I want to have an electroformed stencil made with 0.1mm (4mil) thickness. The PCB pad for the micro BGA has a 0.406mm (16mil) diameter. What size should I make the apertures for t
