Electronics Forum | Thu Sep 02 21:02:55 EDT 1999 | Paul Wareham
We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these sizes?
Electronics Forum | Tue Sep 07 09:11:33 EDT 1999 | Dave F
| We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these sizes
Electronics Forum | Sun Sep 05 03:52:11 EDT 1999 | Brian
| We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these sizes
Electronics Forum | Fri Sep 03 03:56:41 EDT 1999 | Wolfgang Busko
| We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these sizes
Electronics Forum | Fri Sep 03 14:37:45 EDT 1999 | JohnW
| | We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these siz
Electronics Forum | Mon Sep 06 19:59:59 EDT 1999 | armin
| | | We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these s
Electronics Forum | Thu Dec 10 13:27:36 EST 1998 | Dave F
| Dear everybody : | Does anyone have some information about "bleeder pad"? it seems a method to avoid solder shorts across very small SMT pads.If someone have any idea about it, please contact with me , thanks ! | Young: I'm unfamiliar with the
Electronics Forum | Tue Dec 15 22:23:52 EST 1998 | Erhan Kaya
If that's what you mean, here's what we call them: ROBBER PADS... Pretty close to the "thief" I guess. Those come with the design and if the wave soldering direction is not known at the time of design and/or there's no real estate limitation, the rob
Electronics Forum | Thu Jan 13 17:46:04 EST 2011 | davef
We've never seen the defect that you describe, but in wave soldering-land blowholes usually are caused by moisture in the board that out-gasses through the too thin plating of through holes. * Bandaid fix: bake the boards * Long-term fix: Obtain boar
Electronics Forum | Thu Jul 27 11:47:02 EDT 2000 | Jason
i've rotated the board with the same result. What are soldertheif pads. I'm new to wave soldering and this is another new one on me. What did you use? where do you put the pads? please explain as much as you care to...also my leads are 1mm and th
