Electronics Forum | Thu Dec 28 22:39:49 EST 2006 | i want to learn from u
i just thought that it because of difference thickness between the silkscreen and without silkscreen. if we apply the same pressure and dispense time to this two difference location, the glue size will be difference. location with silkscreen will rea
Electronics Forum | Wed May 29 07:41:33 EDT 2024 | tommy_magyar
We use the same component on many different products, never faced a similar issue. However, things I would check are: - stencil thickness (ideally 125um) - additional Z move on the parts around the relay (as suggested by kumarb) - check the packages
Electronics Forum | Wed Jun 20 10:43:59 EDT 2012 | dharbin
Looking for a theta servo motor. Panasonic part # MFG10DALM5BJ. Panasonic can't supply and I have checked several 3rd party sources.
Electronics Forum | Wed Jun 20 10:47:05 EDT 2012 | dharbin
Looking for a theta servo motor. Panasonic part # MFG10DALM5BJ. Panasonic can't supply and I have checked several 3rd party sources.
Electronics Forum | Wed Jun 20 10:47:55 EDT 2012 | dharbin
Looking for a theta servo motor. Panasonic part # MFG10DALM5BJ. Panasonic can't supply and I have checked several 3rd party sources.
Electronics Forum | Tue Nov 07 23:53:52 EST 2006 | mike white
Panasonics HD range of glue dispensers are good for this kind of job. I suppose the placement machines you have may also determine the dispenser machine. If you have Panasonic placement machines for example a Panasonic HD machine may fit into the foo
Electronics Forum | Tue Dec 19 07:16:56 EST 2006 | Nuno
There is many Bond dispenser that have the Option to check the area & adjust in case of NG area . You just make the value of area & interval for check and correct . The Ones that I know is Panasonic HDF (great Output 0.07 tact time ) And Fuji GL5 ser
Electronics Forum | Fri Jun 22 15:06:34 EDT 2012 | toddl
Hi Harb, I am parting out one of these machines, PM me for more information.
Electronics Forum | Thu Sep 21 14:29:58 EDT 2006 | realchunks
Gotcha, I used to be in charge of a pneumatic gun that clipped and bent the leads. Hand held units that worked rather well. The operators where very good at aiming the clipped lead too! Anyway, you may want to visit Panasonic, they have/had a disp
Electronics Forum | Fri May 26 01:50:54 EDT 2000 | Craig
We have no experience in printing glue only in dispencing for short runs. We are finding that our gluing volumes are going up and want to look at screen printing as an option. We are placing 0805 and 1206 chips, melfs, sots and ics. What are the adva
