Electronics Forum | Mon Sep 23 17:53:01 EDT 2002 | steveb
We have both Panasonic MPA3 56mm feeders and Hover-Davis 56mm feeders. You can go wider than this if you need, we also have a 72mm Hover-Davis feeder. You are correct in stating you will need to base plate for the Hover Davis feeders to work. We h
Electronics Forum | Thu Aug 22 02:04:25 EDT 2002 | Bob Willis
I would talk to you suppier of placement equipmennt as Assembleon have experience with running odd form on machines as do Panasonic, Siemens, Mimot and Universal. I have run two lines with machines from your supplier and will be doing a project with
Electronics Forum | Wed May 31 17:37:29 EDT 2000 | Arturo
I�m also having this problem with Panasonic film capacitor. Even when I have the correct pad size according to Panasonic data sheet the tombstoning occur. I am thinking that the problem could be the plating of the film capacitor. The only way I could
Electronics Forum | Tue May 03 15:19:12 EDT 2005 | cuculi54986@yahoo.com
Thanks for the suggestions. We have been going around the dome to pick from the base. The placement machines are Panasonic chipshooters - MV2VB and MV2C. I have several problems with the MV2C. The K-type feeder plates were moved by my predeces
Electronics Forum | Mon Jun 26 12:12:07 EDT 2006 | Rob
Hi JEM, No, it is not required to attach the pads. They have not plated them either, so even if you try it won't be easy. However, the land pattern does supply you with the pads for the "support" pins to sit on & not get soldered to. Semi-helpful
Electronics Forum | Fri Jun 16 00:45:19 EDT 2006 | Richard Robins-Bird
Not all splicing tapes require the use of specialist tooling or splicing plates to make a join. Please see wwww.fujismt.com where a complete range of SMT splicing tapes (Joint Tapes) can be found for use with chip mounters such as Assembleon, Europla
Electronics Forum | Wed Sep 18 14:58:59 EDT 2002 | Claude_Couture
Just to add my 2 cents on the adjustment of pitch on MPA feeders: True: Panasonic do not make it easy to change the pitch on MPA feeders, the thickness of a metal part is what sets the pitch. My solution: for example, I get a 24mm X 12mm pitch MPA
Electronics Forum | Sat Jan 06 10:52:09 EST 2001 | Steve Thomas
I don't know the specs. of our MSHII's, as I'm sort of detached from that part of the process, but supposedly they are capable. Panasonic also recommends we buy all new feeders (well, big surprise there), because of the risks involved with retrofitti
Electronics Forum | Mon Dec 28 12:16:40 EST 1998 | Jon Medernach
Chris, We are involved in several developments using gold stud bump attach. We make a stud bump bonder and have several processes for attach. Solder attach is best done by plating up the substrate, the underfill must be able to provide enough mechan
Electronics Forum | Tue Dec 29 10:24:35 EST 1998 | Earl Moon
| Chris, We are involved in several developments using gold stud bump attach. We make a stud bump bonder and have several processes for attach. Solder attach is best done by plating up the substrate, the underfill must be able to provide enough mech
.gif)
