Electronics Forum | Fri Mar 15 20:56:55 EDT 2013 | marcelorotofrance
At this point all the sensors, switches and solenoid valves were checked. Their electrical signals and actions were phisically checked at the I/O cards level (Panadac 783-065 and 065A). Above mentioned signals were monitored from "I/O Monitor" functi
Electronics Forum | Wed Nov 04 21:18:23 EST 2009 | isd_jwendell
I only have first-hand experience with 2 pick-n-place machines, but both used a small pressure puff to insure part release. I haven't seen any software settings for this, but a small solenoid valve was dedicated to the operation. I recommend you look
Electronics Forum | Tue Jan 09 03:12:59 EST 2001 | Avichai ramot
Hello I need a part for CP-IV3. can enyone help me find the part ergently. THE PART IS: H1068Z pcd2413-02-D24SP VALVE SOLENOID "KURRODA" BEST REGAREDS
Electronics Forum | Thu Apr 16 13:16:05 EDT 2009 | jeffharley
You might try checking to see if the float switches are actually lifting up with the water level, I have seen them get stuck in the open position. Also check to see that the solenoid valve is actually sealing off (closed)
Electronics Forum | Fri Jul 31 17:09:55 EDT 2009 | isd_jwendell
Don't know about Topaz, but on Essemtec machine using SMC ejector, there are separate solenoid valves for vacuum and release. The connectors are identical and side by side. If these connectors were swapped then I would have the symptoms you describe.
Electronics Forum | Wed Mar 27 16:03:01 EDT 2019 | jdengler
Jim, It's been a long time since I worked on one of these so this is going to be a general idea as to the issue. There's a solenoid valve that is controlled by the E-stop ckt. When in E-stop in stops air from entering and vents the pressure lines
Electronics Forum | Mon Apr 10 15:34:53 EDT 2017 | mrich208
Hey Jerry, The valve that sends air to the head of the inserter does not close when you press the "Interlock" button. If you press on the end of the solenoid with a screewdriver to force it the air makes it to the head. If doesn't seem like it is tr
Electronics Forum | Mon Apr 10 14:26:38 EDT 2017 | jdengler
Hi Mark, The status messages for these older UIC machines aren't always as helpful as we would like them to be. What exactly is happening? No air for the whole inserter part of the machine, or the inserter head only? It's been a while since I ha
Electronics Forum | Thu May 20 22:38:01 EDT 2021 | kumarb
For closure to all readers of this thread...many thanks to Michal for this support. Trans-tec (USA) was great in replying to our countless emails on this topic. We sourced a replacement solenoid # A041E1-48W for our Emerald-X = YV88X. The part was a
Electronics Forum | Wed May 19 20:24:09 EDT 2021 | kumarb
Thank you Michal. Very much appreciated. We are thinking along the same lines. However, we are being very afraid to even cut the official wire ties that are securing the head 1 and head 2 wiring. We have a new VAC2 solenoid in transit that will arr