Electronics Forum | Wed Jul 20 16:08:34 EDT 2005 | grantp
Hi, I think the comment about the board height is because the MYDATA checks the board height each time it loads a tool so this is eliminated from being an issue because the machine knows the PCB height. I don't think it's so much what height the PCB
Electronics Forum | Wed Apr 04 09:20:20 EDT 2012 | acsscott
I have continued to try and make this work, but I've had no success. I have tried everything that everyone has suggested. It might be the component height, but I can't change that. I guess I could increase the resistor thinkness, and add some heig
Electronics Forum | Wed Feb 08 12:18:18 EST 2017 | dyoungquist
It could be a part height issue. I have seen a case where an 0402 resistor from 2 different manufactures had different heights. If the height of your 2010 part is taller than you have programmed in the package data, the pick up head may be pushing
Electronics Forum | Sat Dec 12 12:25:14 EST 1998 | David Lombard
| My Fuji IP3 keeps getting the Check Sensor Error. | What is the problem? | This problem is caused by either of two things. First the vacuum chuck get dirty and needs to be cleaned "PM". If the problem is persistant the vacuum chick has worn down
Electronics Forum | Sat Dec 12 12:26:08 EST 1998 | David Lombard
| My Fuji IP3 keeps getting the Check Sensor Error. | What is the problem? | This problem is caused by either of two things. First the vacuum chuck get dirty and needs to be cleaned "PM". If the problem is persistant the vacuum chick has worn down
Electronics Forum | Mon Jan 26 13:30:36 EST 2009 | evtimov
Hello, usually you will place your themocouples on the most critical parts on your board. I would say, very big parts, very sensetive to the temperature parts, heavy parts, parts with big heat-sink.... The easiest way is to solder your thermocouple
Electronics Forum | Tue Jun 29 11:46:56 EDT 2021 | stephendo
It's been a while but what about the nozzle? Is it still springy? And did you check the part data? At one place our machine would be metric or imperial depending on a visitor from HQ. If you are smashing parts on the board that isn't good and if you
Electronics Forum | Thu Mar 21 12:09:28 EDT 2019 | alexcouto
Hello Bukas, thanks again. Since at an early stage I switched heads # 1 and # 6 and they are not compatible, then I went through the manual and figured out why. in order to start at the beginning and check that it had not damaged anything, I put the
Electronics Forum | Mon Jan 02 09:39:34 EST 2017 | dyoungquist
I do not know the limit for component height on Hydra.
Electronics Forum | Sat Jun 27 10:45:18 EDT 2020 | SMTA-Davandran
Hi Indhu, Check for solder paste height. Please manually add solder, mount component and reflow.
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
.jpg)