Electronics Forum | Mon May 04 02:39:31 EDT 2009 | lococost
Have you contacted Cobar? They should have a sample of your batches of pasta they could analyse.
Electronics Forum | Tue Mar 31 12:54:53 EST 1998 | Justin Medernach
| | Can someyone tell me where i can find some informations, | | about optimal design of footpad for pasta dispensing. | John, | Check out IPC-SM-782. This refers to surface mount pad design for surface mounted components. The spec is available fo
Electronics Forum | Mon Mar 30 11:35:20 EST 1998 | John Vestergaard
Can someyone tell me where i can find some informations, about optimal design of footpad for pasta dispensing.
Electronics Forum | Wed Jun 16 15:39:15 EDT 2010 | mikesewell
Keep in mind you'll still need to preheat the assembly to properly activate the flux/drive off volatiles in the paste. Perhaps a convection toaster oven... Add some cooling coils and a freeboard/tube to the top of your pasta cooker or turkey fryer t
Electronics Forum | Tue Feb 11 13:03:05 EST 2020 | astarotf
Evtimov The areas analyzed are a standard oven curve according to the pasta we are using. The channels used are only for measuring the oven temperature profile, not in detail of the QFN component sector.
Electronics Forum | Tue Feb 11 17:05:53 EST 2020 | astarotf
Evtimov thank you very much for sharing this profile, we will perform tests with this curve to see behaviors in the oven and pasta.
Electronics Forum | Mon Mar 30 12:46:14 EST 1998 | Justin Medernach
| Can someyone tell me where i can find some informations, | about optimal design of footpad for pasta dispensing. John, Check out IPC-SM-782. This refers to surface mount pad design for surface mounted components. The spec is available for purcha
Electronics Forum | Thu Dec 20 16:32:54 EST 2007 | gsala
Over here in Eurolandia the following Allois are running like a piece of cake. http://www.krepro.no/tinn_pasta_fluss/NiGe-Stangtinn.pdf It is FUJI patent Formula, sold in Eurolandia by FELDER Germany Really a good help in the Lead Free Wave Solder
Electronics Forum | Tue Feb 11 11:00:13 EST 2020 | astarotf
hello Evtimov Thanks for your answer. I will analyze the curve with our pasta supplier to reconfirm if it is adequate. It would also be helpful if you could share the tin lead curve profile to analyze. The location of the QFN is assembled by the top
Electronics Forum | Sat Dec 04 18:55:38 EST 2004 | Grant
Hi, Yes, all you really need to do is boil the fluid while suspending the PCB above the vapor, so it's quite easy. However I would recommend against dropping the board direct into the vapor cloud, as that would be a very fast warm up, while letting