Electronics Forum | Mon Aug 11 15:57:18 EDT 2003 | Fred Matthews
As the traqnsistion to Pb free manufacturing gains speed and exposure the period between true Pb free solutions and the present is still somewhat distant. Are there any publications or documentation on the use of Pb free components and non-Pb free
Electronics Forum | Mon Nov 28 21:37:37 EST 2005 | milroyperera
Hi, What would be the standard band width for Pb-free soldering? As per my knowledge this should be 3cm to 6cm. What is best?
Electronics Forum | Thu Feb 28 13:28:12 EST 2008 | fsw
In the design stages, we have been asked about the difficulty in soldering a 4AWG (stranded) wire to a PCB for a high current application. Questions - can this be hand soldered normally? What about wave? Process will probably be Pb-Free. All opinions
Electronics Forum | Tue Aug 12 05:48:33 EDT 2003 | davef
There's an identical thread on this page. Look here: http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=6357&mc=7 Consider searching the fine SMTnet Archives when you are bored.
Electronics Forum | Tue Dec 04 14:26:56 EST 2007 | ratsalad
We use the same oven for both Pb and Pb-free assemblies. We have been for about two years. We have not seen any issues with contamination. I can't imagine how any Pb would end up in a Pb-free joint in the reflow oven. The Pb doesn't vaporize, the
Electronics Forum | Sun Nov 06 20:52:34 EST 2005 | milroyperera
Hi Ken What exactly the best reffered angle for Sn/Pb & Pb-free soldering? Is there a site where I can read the basic engineering concepts about this topic?
Electronics Forum | Mon Nov 28 09:14:53 EST 2005 | lupo
Just change the flux. I have had bad experience with IF2005
Electronics Forum | Wed May 24 15:59:34 EDT 2006 | JohnM
I have a product with mixed in Pb free and Pb BGAs. I decide to use SnPb paste with Pb free reflow profile to make it work for both types of BGA. Do I have a reliability solder joint issue by using this method? How is your opinion on this case? Can
Electronics Forum | Sun Feb 11 23:18:44 EST 2007 | M.Haris
1. If I go to the Pb-free solder paste, is it necessary that I have to change my reflow oven OR just by changing with respect to solder paste specification, I can reach my goal? 2. What is the �Low- Temperature Phase� in any solder paste alloy? 3.W
Electronics Forum | Mon Jul 10 09:25:47 EDT 2006 | nodlac
Here is a nugget from the Data Sheet... Wave Soldering: Excess moisture on the PCB during soldering may lead to random solder balling and poor wetting of some solder joints. IT IS IMPORTANT that the flux solvent carrier (water) is fully evaporated a