Electronics Forum | Fri Nov 23 02:46:11 EST 2001 | anders
We are currently handsoldering PCB jumpers. Does anybody have any experience on how the PCB-pad footprint design should be for screenprinting PCB jumpers to ensure that the connection is soldered?
Electronics Forum | Tue Nov 27 01:43:29 EST 2001 | Anders
The reason why we are using soldered PCB jumpers is that it is cheaper than dip-switches, 0 ohms resistors, etc. Field updating is also easier. We are producing different variants of some of our products. It would nice if we could presolder the PCB
Electronics Forum | Tue Nov 27 15:57:58 EST 2001 | mparker
rather than applying jumpers, try thinking it another way. Have all possible jumper connections pre-made by the fab design. Use an exacto or dremel to "open" the undesired paths by removing a bit of copper trace. total flexibility, only one fab make
Electronics Forum | Mon Nov 26 19:58:54 EST 2001 | davef
Depends on what you're talking about. For instance: Jumpers between pads: Why not use SMT jumper components? Long ECO jumper runs: When we have a serious problem in the design of our boards, we contract thick film additive jumper work. Search th
Electronics Forum | Tue Nov 27 10:16:07 EST 2001 | davef
Oooo, I get it. We do that trick on the wave solder side of boards. On the bare board, during design / layout, the basic shape of the jumper is a 125 thou disc of copper [that of course is eventually covered with whatever solderability preservative
Electronics Forum | Thu May 28 08:39:13 EDT 1998 | Rob Williams
I have a component that is glue cured on the bottom of a pcb. The component is a 1206 size jumper. It is made up of iron/nickel alloy. The problem I am having is that the part will fall off the board during wave solder. Is the component not able
Electronics Forum | Thu May 28 08:38:43 EDT 1998 | Rob Williams
I have a component that is glue cured on the bottom of a pcb. The component is a 1206 size jumper. It is made up of iron/nickel alloy. The problem I am having is that the part will fall off the board during wave solder. Is the component not able
Electronics Forum | Wed Jun 03 09:48:47 EDT 1998 | Gary
| I have a component that is glue cured on the bottom of a pcb. The component is a 1206 size jumper. It is made up of iron/nickel alloy. The problem I am having is that the part will fall off the board during wave solder. Is the component not abl
Electronics Forum | Thu May 28 09:48:08 EDT 1998 | Steve Herring
| I have a component that is glue cured on the bottom of a pcb. The component is a 1206 size jumper. It is made up of iron/nickel alloy. The problem I am having is that the part will fall off the board during wave solder. Is the component not abl
Electronics Forum | Tue Nov 11 16:01:09 EST 2003 | KSimpson
Adam, As for stripping the boards.. get them right to start with. Believe me you don't want to clean them. If you have to remove the coating most conformal coating brands offer a removal agent that has been tested on most all component ranges. IF yo
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830