Electronics Forum | Wed Apr 06 07:28:54 EDT 2005 | liv2xplr
Besides the solder mask suppliers, I would contact some makers of exposure and alignment equipment. Try OLEC (www.olec.com) - they make different types of expsoure equipment. Another good source is a company called All-4-PCB (they rep a number of P
Electronics Forum | Thu Apr 07 02:38:20 EDT 2011 | aungthura
I didn't know the difference for BGA. We found solderability probelm as show in attach.Then, we called to PCB maker and they said that it could be caused because of PCB finishing. Do you agree this probelm was happend because of PCB finishing? Unfor
Electronics Forum | Thu Jan 04 02:54:20 EST 2018 | buckcho
Hello, I have experienced the same problem. It is a problem with your PCB manufacturer. If the paste goes away from the pads it is most likely PCB problem. How long does it take to produce from top to bottom side? The longer it takes, the worst the p
Electronics Forum | Wed Sep 18 18:10:15 EDT 2002 | davef
IMHO, this finish is more cosmetically appealing than technically desirable (and VERY profitable for the PCB maker). That editorial comment aside, you're correct. Increasing the concentration of gold: * Hardens the solder. * Increases the liquidou
Electronics Forum | Fri Aug 25 05:34:50 EDT 2006 | cpliew
Hi Board House, Thank you for your inputs. Do you see the similar problems to flex circuits makers?
Electronics Forum | Fri Jun 04 01:38:09 EDT 2010 | nikopolidis
Thanks My mistake on the previous post is that the Temperature will be way beyond 90C maybe reach to 400c as the PCB will be placed under the Heating plate of the sandwich maker! So my concern is the heating tolerance! Appreciated your knowledge b
Electronics Forum | Mon Sep 11 20:32:19 EDT 2017 | danielgigavis
Our company is seeking partnerships to venture out to oversea markets. Need representatives/agents to promote our AOI tools to PCB makers. If you are interested please contact me at dl787@gigavis.com, my name is Daniel Lee. www.gigavis.com
Electronics Forum | Wed Dec 12 05:49:51 EST 2012 | clausule
today my pcb maker told me they can't get all components on the board. I was wondering if some might have suggestions for improvement. Attached the schematics and pcb design. the part outside the white lines does not fit on the board. pcb size is 15x
Electronics Forum | Wed Jun 08 13:49:48 EDT 2011 | sonofptolemy
Hello, I am having a problem with HASL PCB's after it comes back from the stuffer. To me it looks like oxidation and it causes poor wetting. This leads to a bunch of problems all of which have different symptoms but the cause is this oxidation proble
Electronics Forum | Thu Oct 01 06:44:44 EDT 1998 | PARK KYUNG SAM
Are there anyone who can give me the answer about solder ball problem? We have 12 layer PCB and double sided PCB. After one side reflow soldering We found lots of solder ball under the PCB. The solder ball was coming out from via hole. So when w
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
