Electronics Forum | Tue May 02 14:18:50 EDT 2000 | Erhard Hofmann
I think it is very nice to have the feature of getting informed when someone answers to a question I put on the smt.net. But (and that's a big but): If you send out an email why can't you just include all the informations you want to send in the emai
Electronics Forum | Tue May 28 16:19:52 EDT 2002 | zanolli
Hello Floyd, Yes, special tooling is required. The tooling usually consists of a press, push-in tooling and support plate tooling. The presses can range from relatively simple arbor type presses to automated hydraulic presses with sophisticated con
Electronics Forum | Mon Feb 12 02:17:32 EST 2007 | Wayne
Most of the semi-con is using SAC305 balls. Only the PCB assembly house feels the heat, but semi-con never feels any pressure.
Electronics Forum | Mon Apr 29 05:25:13 EDT 2002 | ianchan
Hi, we do Sn plated I/O pinning insertion into Ni/Au thru' holes. no problems here so far, as we cater for the "interference" (fit-allowances) of the I/O pin into the thru' diameter, via improved PCB thru' hole designs. before this cater/considerati
Electronics Forum | Mon Oct 24 06:31:31 EDT 2022 | richardcargill
We have a similar board and came up with a quick and dirty solution. The board locates via pins onto a manual desk press with strategically placed feet to break the mouse bite. Not really much quicker than doing it all by hand, but after a thousand p
Electronics Forum | Thu May 15 17:34:17 EDT 2014 | taiji
I always made tests with gauges on top or bottom surface of the PCB, before, during and after the process that we wanted to check. But I never tried to do it on internal layers of PCB. Don't know if that is possible. Regards
Electronics Forum | Thu Jun 07 05:11:42 EDT 2012 | cp38260
Hi, I have pcbs (Duroid/RT 5880) with raw copper, soldered in vapour-phase chamber at 230 degrees Celsius. During soldering, copper gets tarnished. Cleaning with Vigon A250 removes the tarnished layer. Indeed, in the VigonA250 techn. datasheet it is
Electronics Forum | Thu May 15 09:55:16 EDT 2014 | julianf
Tmo, Thanks for your reply. It gives good advise about how to perform tests. The type of strain gauges that I want to design are inside the PCB at various layers and I want to read the data during the press step. Do you know if these prefabricated
Electronics Forum | Wed May 14 10:20:37 EDT 2014 | julianf
Hello all! For my mechanical engineering study I want to etch a strain gauge in the Wheatstone bridge configuration in a copper layer of an PCB. The goal is to measure the strain occurring in an PCB even during the press process! We can measure with
Electronics Forum | Fri Dec 23 06:09:04 EST 2005 | Slaine
good report showing lots of sections and compairng differnet pcb finishes http://www.smartgroup.org/experience/experience%20report%202005.pdf
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830