Electronics Forum | Wed Oct 28 09:28:02 EDT 2009 | spitkis2
I agree with you. Personally, I would either return them and look for a new supplier or scrap these boards. Unless your customer provided these boards and gave you the go ahead to populate them, they will not be too pleased about the build.
Electronics Forum | Fri Oct 31 18:08:34 EDT 2008 | m79d
thank you both for the input ok so i understand the hole is on a 5mmx5mm center the pin seems to be 3mm. About 3mm of the board goes under the clamp rail so the tooling strip must be wider than 5mm as the fiducial also needs to be on it. Mark_m yo
Electronics Forum | Fri Sep 06 13:45:02 EDT 2002 | Cris Campos
To Scrap or not to Scrap? We have the answer to your problem. Visit http://www.circuit-techs.com for more information regarding Printed Circuit Board Repair, Rework & Modification in accordance to IPC 7711 & 7721.
Electronics Forum | Fri Oct 16 21:17:04 EDT 1998 | Scott McKee
| | With current soldering of stranded wires to pcb assy's the wire tends to be very brittle and can break with very little movement of the wire. We use a low residue cored wire. Anybody with advice or who has seen a similar problem/knows how to over
Electronics Forum | Thu Jul 24 16:57:57 EDT 2008 | arminski
Hi Guys, I was asked by our QA Supervisor on how to scrap electronics boards. We have Populated PCB's that are already scrapped and would like to permanently mark them that they are Scrapped... Is there any recommended method of marking scrap PCB's
Electronics Forum | Thu Aug 04 16:41:45 EDT 2011 | kkay
Does anyone have more information on recycling scrap pcb's for gold content or a company that does it? Thanks
Electronics Forum | Wed Aug 05 11:04:33 EDT 2020 | ehess
What is the proper way to discard scrapped pcb's, pcba's and potted pcba's?
Electronics Forum | Fri Jul 24 02:57:05 EDT 2009 | fede
I use Center Edge, and adjust stencil offset. It's very easy, you just have to give it the PCBs width. An other advantage is that If your PCB has scrap strips, and you lose them, or PCB changes, you can print it anyway.
Electronics Forum | Fri Jul 25 10:48:50 EDT 2008 | mrmaint
we would spray paint them red
Electronics Forum | Wed Jan 27 15:14:14 EST 2021 | stephendo
Ask your PCB suppliers what they do with their scrap FR4. Especially if any are local to you. I predict that you will not be happy with their answer.
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
