Electronics Forum | Fri Sep 24 13:44:06 EDT 1999 | Eric Lee Williams
| | The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y table
Electronics Forum | Fri Sep 24 20:33:44 EDT 1999 | Ron Gillam
| | | The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y tabl
Electronics Forum | Fri Jul 28 08:08:18 EDT 2006 | Chunks
Screen printer, placement machine(s) and oven. You may also need a hand insertion line, selective solder or wave soldr and some form of electrical test. There are a ton of name brands that no two people can agree on. To get a better feel for what
Electronics Forum | Mon Aug 20 05:53:26 EDT 2007 | erhard
Hello all, we are about to modify a Universal Radial 5 so the machine will be able to insert radial components with lead pitch 3.5mm and 5mm. The 3.5mm components are ELCOs which are getting inserted all the way to the component body so they sit fi
Electronics Forum | Sun Jun 16 08:00:51 EDT 2013 | zaldytorres
Does anyone have suggestion how to modify radial insertion machine to 3.5mm pitch? I have to insert 3.5mm pitch Ecap but the industry standard radial machine could mount only 2.5 or 5 mm pitch. changing PCB or parts is not an option as it is not appr
Electronics Forum | Thu Dec 23 15:10:50 EST 1999 | Victor Salazar
What we did was design or panels with routed out edges held on by tabs. This was very effective. All we use is a pair of pneumatic scissors to cut off the tabs. We are using from single-to 13 layer PCB's and we have had no problems with delamination
Electronics Forum | Mon Oct 03 05:10:19 EDT 2016 | robl
Hi Nikhilesh, It was a long time ago, but we used to buy the nickel in reels then had a cut and feed station on the smt machine with selectable sizes. We did many types of boards in very large volumes, and usually the Nickel strip was soldered to t
Electronics Forum | Tue Dec 07 22:13:43 EST 1999 | sin
Like Wolfgang said, the breakaway tab is just another bar added to the edge of the pcb. This breakaway tab can be added by the FAB house in addition of extra cost...You can write DFM for your customer to see if they will pay for the cost or not...if
Electronics Forum | Wed Sep 11 10:48:02 EDT 2013 | gregp
Hi Reese, The UIC machine is (was) good for higher volumes. Do you think these machines are less appropriate for smaller lot sizes and PCB's with just a few through hole parts? Also, are the UIC through hole machines still fully supported with ampl
Electronics Forum | Fri Apr 15 11:12:30 EDT 2016 | joelperez
Thanks Dave for the reply. I understand there is + and - to each process. We have been doing v-score for a long time and for the most part it has work for us. As PCAs become more dense and components are squeezed to use most of the PCB space, it now
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830