Electronics Forum | Wed Jun 13 14:33:32 EDT 2018 | beavispkp
I'm looking for a supplier of ESD safe liners/netting/mesh we can use in our PCB wash baskets. Any help is appreciated.
Electronics Forum | Thu Jun 14 20:33:50 EDT 2018 | davef
Try: AGI: agicorp.com/products/tooling/wash-baskets 256-858-3300 JENSEN Tools: jensentools.com/desco-41403-esd-safe-pcb-wash-tray-liner-18-x-18/p/482-89 800-225-5370 Stone Mountain Tool: stonemountaintool.com/fixtures/products/wash-fixtures/ 800-
Electronics Forum | Fri Jul 28 12:13:38 EDT 2017 | dontfeedphils
Ironically enough, inline wash system belts work well for placing on top of small assemblies inside wash basket to avoid bouncing around like you've seen. This of course assumes you have access to an old belt like that. Point being, try to find som
Electronics Forum | Tue May 25 12:24:17 EDT 2021 | bukas
is Mark3 program started on startup or do you start it manually? It can be like this if you run it manually. Other cause is bad contact in PCB slot or connector in 90% cases. Wash then with contact cleaner and insert and pull out few times to clean c
Electronics Forum | Fri Oct 16 13:11:49 EDT 1998 | Steve A
The Kyzen product was brought to my attention from a chemist at Kester solders when I asked him what could remove no clean residue from a PCB that had been built weeks earlier. We soaked it in the Kyzen for 8 minutes and ran the board through the aq
| 1 |
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)
