Electronics Forum | Wed Nov 23 07:39:14 EST 2005 | chunks
Shorted to the sheild or the BGA balls are shorted? Sheilds move a lot during reflow. If this is the case, place some adhesive or peelable solder mask on either side of the shield and baords to stop it from moving.
Electronics Forum | Thu Feb 22 20:53:44 EST 2001 | davef
You're not sposed to pull the mask from the BGA when reworking it!!!! ;-) Well, if you insist. You can be as fancy as you want. Basically, all you need to do form a dam to prevent the solder from flowing from the pad to the via and starving the
Electronics Forum | Mon Oct 11 08:34:52 EDT 1999 | C.K.
Thanks for the acvice, Dave and John. Like I stated above, I didn't feel comfortable with changing wave parameters since I knew that we'd be compromising our wave quality. I'll try the peelable mask thing, reprofile, and let you guys know what i fo
Electronics Forum | Tue Feb 19 11:08:22 EST 2002 | Chris Anglin
Guideline for Tenting Interstitial BGA Vias It is difficult to give a complete recommendation on via tenting without an idea what process conditions are required (ex: wave pass, double reflow, rework etc.). Via Pads (as Test Points) - On Bottom
Electronics Forum | Sun Oct 10 17:50:00 EDT 1999 | JohnW
| | We've recently encountered this problem where one of our .050" pitch BGA's were reflowing at the wave thus causing shorts... The board was profiled with probes stuck to a QFP solder joint, an 0603, and one of the BGA joints. There was an almost
Electronics Forum | Mon Oct 11 11:13:32 EDT 1999 | Wirat S.
| | | We've recently encountered this problem where one of our .050" pitch BGA's were reflowing at the wave thus causing shorts... The board was profiled with probes stuck to a QFP solder joint, an 0603, and one of the BGA joints. There was an almo
Electronics Forum | Mon Aug 04 11:34:45 EDT 2014 | spoiltforchoice
Well our small UK based company is I guess in a similar situation, there isn't the volume or value to justify an expensive solution for fiddly rework tasks. But it would certainly be nice to have one and may become more important in future as people
Electronics Forum | Fri Mar 17 14:53:08 EST 2006 | Board House
Hi Brad, Being that I work for a board house here is my take on this issue. In the past it used to be 1 scrap per palt up to 10% of the total order. scrap is supposed to be sepperated to location and packaged sepertaly. Then it turned into No Scra
Electronics Forum | Sun Aug 15 11:02:37 EDT 1999 | Jeff Ferry
| Ladies and Gentlemen, | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I would hav tremendous
| 1 |
