Electronics Forum | Mon Jul 03 14:47:35 EDT 2000 | Ashok Dhawan
In a typical flowline assembly of circuit boards, what are the different methods used for tracking WIP ? I can think of : 1. travel cards - not suitable for panelised boards 2. Marking ID# on board at various operations while board is being built.
Electronics Forum | Mon Aug 19 11:13:18 EDT 2002 | ksfacinelli
I would like to understand what different options people are using to place low volume / odd form parts. I am very familiar with the tweezers / vacuum pen method however this can be less than desirable. I am looking into a manual pick and place to
Electronics Forum | Sat Jan 23 07:08:54 EST 1999 | Graham Naisbitt
| I have boards coated with Humiseal 1B73. At a late point mfg. site we need to remove a series of 0603 resistors for optioning purposes. I have been trying to determine the fastest, easiest way to re-coat the pads after removal. Drying time of the c
Electronics Forum | Wed Jan 27 09:00:56 EST 1999 | Chris Fontaine
| | I have boards coated with Humiseal 1B73. At a late point mfg. site we need to remove a series of 0603 resistors for optioning purposes. I have been trying to determine the fastest, easiest way to re-coat the pads after removal. Drying time of the
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
| 1 |
.gif)
winsouce.jpg)
