Electronics Forum | Thu Nov 24 16:41:10 EST 2011 | captcaveman
just purchased Philips Comet, Orion and Eclipse machines and I was wondering if there was anywhere i could get the manuals for them? Any help is very appreciated...
Electronics Forum | Wed Nov 16 09:33:39 EST 2005 | SuMoTe
I can't help you with most of that, but heres a starting point. "L013: 2nd limit over" means that one of your axis is showing outside operating boundries, as in placement head is too far forward. Make sure all your devices are not pushed out to thie
Electronics Forum | Tue Nov 15 19:31:54 EST 2005 | eeltec
>I/OPERATION ==> >1/RUNNING ==> but any command that I try gives an E100 error and in the left side of the monitor a square with: Conditions Initialized Waiting Emg stop (in red) org incmp (in red) Interlock (in red) data comp Use Vac
Electronics Forum | Fri Nov 18 02:42:46 EST 2005 | vinitverma
Greg, I recently faced this problem at a customer though the machine was Topaz X but the problem was same. So I suggest you first check if the GOOD LED is ON on the Servo card down in the MCX box. Also check the same GOOD LED on the System board in
Electronics Forum | Mon Mar 28 18:05:13 EST 2005 | darby
The Yamaha manual is pretty straight forward on this one so I presume the "Philips" is as well. Go to the Maintenance, Repair and Adjustment chapter and look up Drift-Adjusting. It is in the Controller section. If you don't have a manual let us know
Electronics Forum | Sat Mar 26 14:21:01 EST 2005 | andras
My CSM pop-ups this error after power on: 243 X DRIFT ADJUSTMENT NO GOOD and then latch-up. How can I solve this problem?
Electronics Forum | Wed Dec 07 11:12:17 EST 2011 | thanh
go to Components Info. F4 to Pick & Mount Info scrool down to Mount Action change to Normal instead of Fine.
Electronics Forum | Wed Dec 07 02:35:28 EST 2011 | mk15
Hi, I am looking for help with Error Philips Comet, Start Procedure -OK, INTIAL SERVO ORIGIN -OK, AUTORUNNING -OK, PCB START -OK, FIDUCIAL -OK, PICKUPCOMPONENT -OK, NEXT-ERROR E2 CORRECTION DATA ERROR(CORRECTION DATA IS NOT LOADED OR FAILED TO ADJU
Electronics Forum | Thu Dec 08 01:17:35 EST 2011 | mk15
Hi, I look Pick & Mount and Mount action was NORMAL - OK. When the head pick component then stop outside lamp housing (fixed camera - recognition camera) and then discard component. It repeat 3x, and Error E2. When I do adjust assistant for componen
Electronics Forum | Thu Sep 29 18:48:19 EDT 2011 | jrsmachine
We have a Philips CSM84VZ which we acquired several years ago. It has been running fine until recently when a new employee ran it unsupervised. Since then, when in run mode, it wont't run, but just displays error code "#79:operation interrupted". our
