Electronics Forum | Fri Mar 07 04:53:12 EST 2008 | vinitverma
Hi Wayne, First, all Gem machines including Topaz, TopazX, Sapphire, etc... have the same feeders. You can use either FV feeders (which were the ones when Topaz was introduced), or CL feeders (which came when Topaz X was introduced). Both types of f
Electronics Forum | Mon Nov 12 12:00:59 EST 2007 | wayne123
A philips Topaz is a good machine, I have accurately placed 0402's without a problem, Fine pitch QFP no problem, BGA's not a problem, I am not familiar with the TP9 so hopefully the other guy can answere questions on that, The Topaz is rated at about
Electronics Forum | Mon Nov 12 13:35:34 EST 2007 | dyoungquist
MyData TP9s Work well in high mix applications because change over time from 1 job to the next can be done in as little as 15 minutes if you have the right mix of magazines/feeders. Component placement rates vary depending on which component you ar
Electronics Forum | Tue May 01 13:52:51 EDT 2007 | jasont
plz advise if the below feeders are compatible on CSM 46/60 (are they downwards compatible?); 1. Philips series FV-84-xxxxxC, model PA2903/70 (2,4 pitch, 8mm) QTY=29 2. Philips series FV-82-7-xxxxD, model PA2903/73 0603-type (2,4 pitch, 8mm
Electronics Forum | Tue Feb 15 14:25:08 EST 2000 | Sergey
Dear Sirs Good business day! I need the following feeders for CSM60 machine: - Stick feeders: 1. 20 mm x 1 2. 13 mm x 3 3. 8mm x 7 - Tape feeders: 1. 16 mm, 9" x 7 you seems to be have not this 2. 24 mm, 9" x 3 3. 32mm, 9" x 1 - Manual tray feeder
Electronics Forum | Mon Nov 20 04:37:34 EST 2000 | Paul Gerits
Dear Mr. Kelley, You can contact the local Philips EMT organization or the head office in the Netherlands. We have pre-owned feeders in stock, if the ones you require are available you can request. contacts: rein.sprokholt@philips.com (region euro
Electronics Forum | Mon Sep 04 02:57:40 EDT 2017 | nikkilouie
Hi Guys, Is there anyone knows where can i buy new/used feeder for Assembleon Philips Gem Topaz. we are in needed at least 10 pc.of a FV type feeder for 0402 component. any help would be appreciated. Best regards. nikz
Electronics Forum | Wed Nov 08 18:30:19 EST 2000 | Rob Kelley
I have been earnestly seeking out a resource from whom I might purchase used Philips feeders for the ACM line. Due to its relatively recent introduction into the market, these are rather hard to find, and have not had much luck going through Philips
Electronics Forum | Wed Apr 03 16:27:39 EDT 2013 | gregp
Does anyone have a master cross reference chart for Yamaha/Philips/Assembleon pick and place machines? In particular I am looking to know what the Yamaha models equivalent models are in the Philips/Assembleon line up. The other important bit of inf
Electronics Forum | Fri Aug 03 01:44:38 EDT 2007 | pavel_murtishev
Good morning Steve, What does optimizer say? What is the error generated by optimizer? Could you tell me exact error optimizer gives? Topaz ties to fit all feeders mechanically into the feeder plate when optimization starts. Optimizer generates an
winsouce.jpg)
