Electronics Forum | Sat Mar 03 03:56:04 EST 2001 | wister
I had confused by same problem, the reason I found is the interval between wave soldering and cleaning is too long and did not set the temp. of D.I water at 120F~150F. Kester flux is good. Rgs, Wister
Electronics Forum | Wed Jul 29 03:32:57 EDT 2009 | dilogic
We recently started to use wave-soldering. As total newbies in that field, we got successful results most of the time. Howewer, this batch of PCB's had a lot of resdiue, as shown on the picture. Most of it is most likely flux, but on some areas even
Electronics Forum | Fri Jul 31 02:59:52 EDT 2009 | dj_jago
I can't open the picture but if it is webbing and you are running with an alcohol based flux (non VOC free) another thing to check is the Specific Gravity.
Electronics Forum | Fri Mar 02 15:44:26 EST 2001 | traviss
Is this after wave or wash? Its too bad the archives are gone this one has come up a bunch of times. Most of the time its caused by rosen or no clean flux being put through a water wash. There are several other possibilities. You will probably hear w
Electronics Forum | Thu Jul 07 15:32:37 EDT 2005 | saragorcos
Hi Lloyd, Have you done any ionic analysis to find out what the flux residue is composed of? If you can eliminate the source residue, then your problem obviously should go away. Though tombstoning isn't known to be much of a functional problem it i
Electronics Forum | Sun Aug 29 19:17:34 EDT 2004 | aqueous
Chen, It is always best to place one�s effort on determining the cause and content of the residue rather than trying to work around it. The first thing you must determine is the nature of the residue. Is it flux? In many instances, the residue is
Electronics Forum | Fri Jan 31 03:39:26 EST 2003 | NP
EC7M is clean up solvent that can help to prevent white residue problem. It made from Orange shield. Good luck
Electronics Forum | Thu Apr 13 08:18:46 EDT 2006 | davef
Do a FITR analysis of this white material to help direct you in eliminating the choices. What do your paste and board suppliers say?
Electronics Forum | Mon Feb 03 11:17:55 EST 2003 | Randy Villeneuve
White residues are a common problem when cleaning no-clean fluxe residues. The white residue forms when the flux residue is partialy removed, etc. Alcohol should not be your only solution for cleaning. In general, solvents may attack some plastic par
Electronics Forum | Tue Apr 11 11:47:56 EDT 2006 | amol_kane
Hi SMTnetters, I have a white residue coating all over my reflow oven innards (almost looks like white fungus). How can I absolutely be certain that it’s flux and not anything else?are there any tests available for this? I am planning to check the ov
.png)
.jpg)