Electronics Forum | Wed Jan 05 17:56:30 EST 2011 | ppcbs
I am looking for a No-clean or water soluble solder paste, Sn63/Pb37 alloy, 15 - 25 microns (T5). I need to print with a 4.8 mil stencil opening. Does anyone know where I can get 250 to 500 grams in one week or less?
Electronics Forum | Wed Sep 04 13:58:36 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the response. 1. Function 30 gives me a consistent 182-185, even after nozzle changes. I can vary this by changing mod code 15 and I have been advised to aim for 90-110, but it doesn't seem to make any difference so I've go
Electronics Forum | Wed Sep 04 09:47:41 EDT 2019 | smrsteve
Hello All, I've just bought a Quad 4c pick & place machine. It's so close to actually building boards, but just doesn't quite get there. I was wondering if there's somebody out there with experience of these machines that might be able to help...?
Electronics Forum | Mon Nov 13 04:57:27 EST 2000 | Wolfgang Busko
Hi Richard, I assume that you deal with a component that has 20mil pitch. In this case depending on your pad design you get from 8 to 10mil spacing for your apertures. With a slight reduction of the aperture (10 to 15% for avoiding shorts)and a 6mil
Electronics Forum | Wed Nov 15 11:00:35 EST 2000 | Finepitch Services
"depending on your pad design"... To me, Wolfgang gave you the biggest secret... I guess he meant the real pad width you get on your board is the start point. Get the average measurement in mils and then cut it from the sides at the percentages he h
Electronics Forum | Thu Jun 16 11:07:15 EDT 2005 | Arek
Walcome, I am looking for an information about repetability and accurancy of placing component 0201 on the machines: Assembleon Topaz Xi II and Emerald Xi II. What is your experinces and is it a good chose to buy them for placing component 0201.? Do
Electronics Forum | Fri Jan 12 15:32:53 EST 2024 | madisreivik
Indeed I found some vacuum problems, one replaced small hose was not fitted correctly. Lets see if that helps :) Great thanks ! Also, Travis, do you have any information how to adjust the milk-plexiglass slitted covers on line scan cameras ?
Electronics Forum | Tue Jan 23 15:28:58 EST 2024 | triplettx3
contact Mike Forseen at SMT research he is very knowlegable on all the older Fuji machines, i have alot of spare parts if you ever run into a jam.
Electronics Forum | Wed Oct 15 15:31:55 EDT 2008 | dmoquin
set the vision number to 255 in the PD. This will shut off the vision processing
Electronics Forum | Wed Oct 15 15:47:35 EDT 2008 | mbrunton
Thank you Dana and Stephen, I will give it a shot now. I'm not surprised it's not in the manual... apparently there is tons of stuff not in the manual and Fuji tells me they have no idea what half of the unwritten stuff means :)
.gif)
winsouce.jpg)
