Electronics Forum | Thu Feb 09 10:29:37 EST 2006 | stepheniii
I worked at one place where they had a dishwasher. They had stopped using it by the time I got there. But if they had kept using it I would have gotten a clean glass and put it in to see how clean it came out. I think after a while with only one tan
Electronics Forum | Mon Jul 10 21:01:06 EDT 2000 | Dave F
Edmund: Responding to your questions: 1 What is purpose of using DI water to wash a PCBA? Compared to tap water, DI water is less likely to leave: � Metal cations on sensitive components. � Salts of Ca, Mg, and other stuff on metals on the assemb
Electronics Forum | Sat Jul 08 00:06:16 EDT 2000 | Edmund
Can any pls enlighten me what is the purpose of using DI water during washing of PCBA. If the board is not wash using DI water , what will happe? What is the range of resitivity reading should be. Rdgs...
Electronics Forum | Mon Jun 19 09:47:23 EDT 2017 | georgetruitt
You have a lot to think about! What does the flux manufacturer recommend as far as specifics like water temp or pressure? Do they recommend high temp di-water a detergent or saponifier? Do you currently have a cleaning machine, batch cleaner or inl
Electronics Forum | Mon Mar 29 11:15:58 EST 2004 | davef
Grant & JDumont: You should not have this white residue on your wave soldered connections, using VOC flux [but you know that, anyhow]. Applying too much flux is the likely cause. Other possibilities are: * flux contamination * solder contamination
Electronics Forum | Tue Mar 30 07:20:20 EST 2004 | davef
If you can rub it off, it's unlikely to be a solder mask problem. Try the "excess flux, flux contamination, solder contamination" angle.
Electronics Forum | Thu Apr 01 03:22:59 EST 2004 | paul pmd
Deltawave flux pump continously runs while in run mode. After the pump there is a flux manifold distribution block. When switching between fluxes not all previous flux is purged or drained. When no clean is installed some cross contamination may occu
Electronics Forum | Fri Mar 26 10:23:55 EST 2004 | Mike Konrad
Patrick, When you say "no-residue" what exactly do you mean? Is there truely "no-residue" or is it "no visible residue"? What type of ionic contamination results have you experienced? If you take a bare board that measures 0.0 NaCl and reflow it
Electronics Forum | Fri Mar 26 12:26:31 EST 2004 | Mike Konrad
Hi Patrick, With all due respect, it is easy to quantify zero. You made a claim that your flux produces ZERO residue. There are several industry-standards (IPC and Military) of determining the cleanliness of post-reflowed circuit assemblies. Th
Electronics Forum | Sun Mar 28 22:17:36 EST 2004 | Grant Petty
Hi, I would also be interested in this thread, but our problem has a different twist to it. We have good results from our reflow with Koki no clean paste, however when we pass the boards through the wave solder machine, the flux in that leaves a fog
