Electronics Forum | Tue Nov 29 11:45:35 EST 2016 | ttheis
I was able to repair the original power supply for the printer again with parts from another similar power supply on ebay. At first the machine didn't power up properly even though the supply voltages were all good on a volt meter when tested befor
Electronics Forum | Mon Mar 23 15:41:46 EST 1998 | Stuart Adams
Should I use thermals or direct connects on vias from BGA pads to power planes. The via is connected to the BGA pad via a short 8mil trace.
Electronics Forum | Thu Mar 28 08:12:19 EDT 2019 | carehawk
We had an issue where a vision cable got cut and a few wires were exposed and possibly shorted. We fixed the cable and since then have had numerous errors with the last one being pneumatic power down. We have air to the machine and have checked the p
Electronics Forum | Mon Jul 17 20:50:42 EDT 2017 | davef
For service related problem, contact Dave Byker at 847-913-0162
Electronics Forum | Wed Jul 12 17:05:22 EDT 2017 | rodrigo
Hi all, Our Fuji cp6 woke up with a bad power supply (ps) this morning. The ps is one of two 24vdc (Corsel P300E-24). There is one inside the cabinet and one on the door where the cpu card is. The bad one is the one inside the cabinet. So we had anot
Electronics Forum | Tue Mar 24 13:21:16 EST 1998 | Earl Moon
| Should I use thermals or direct connects on | vias from BGA pads to power planes. The via is | connected to the BGA pad via a short 8mil trace. Thermals are safest. However, I have had no problems using direct connects provided parameters are capab
Electronics Forum | Mon Feb 10 16:13:56 EST 2020 | john_kim
Hello, Would you please recommend a proven Short circuit tracer/finder ? From time to time, to fix defective boards, I need to find a source of bridge between Power and Ground. I had used a simple Shortsniffe, but it was very hard to trace the origi
Electronics Forum | Tue Feb 18 18:33:57 EST 2020 | jerlong2020
I have used infrared imaging to find electrical shorts on logic boards between the 5 Volt buss and ground. You can power the electrical short up to draw 50 to 100 mA and then look for the warm spot in the infrared display.
Electronics Forum | Wed Feb 19 13:08:23 EST 2020 | john_kim
Thank you again Jer !
Electronics Forum | Wed Feb 19 12:59:59 EST 2020 | jerlong2020
Hi John, We had a FLIR system with interchangeable lenses and good thermal resolution for the time (15 years ago). I see the new ones now at a fraction of the cost which we paid and they have better resolution. Amazing how the infrared imaging tech