Electronics Forum | Thu Jul 16 10:52:34 EDT 2009 | desrtscrp
Lost hard drive and backup software for our pre 2000 Cyberscan Cobra 2D Laser Profile Scanner. If anyone out there could help me find a copy for purchase I sure would appreciate it! Thanks!
Electronics Forum | Tue May 28 11:34:51 EDT 2002 | bphilips
What types of solder pre-forms are used on connectors?
Electronics Forum | Fri Jun 19 14:05:12 EDT 1998 | BillChristian
We are discussing the importance of pre-hating components or the pcb in order to repair the board. I am interested in other peoples opinions on pre-heating.
Electronics Forum | Mon Jun 22 21:42:02 EDT 1998 | Dave F
| We are discussing the importance of pre-hating components or the pcb in order to repair the board. I am interested in other peoples opinions | on pre-heating. Bill: Some folks we talking about preheating capacitors earlier this month in the threa
Electronics Forum | Fri Jun 19 14:05:12 EDT 1998 | BillChristian
We are discussing the importance of pre-hating components or the pcb in order to repair the board. I am interested in other peoples opinions on pre-heating.
Electronics Forum | Mon Jun 22 21:42:02 EDT 1998 | Dave F
| We are discussing the importance of pre-hating components or the pcb in order to repair the board. I am interested in other peoples opinions | on pre-heating. Bill: Some folks we talking about preheating capacitors earlier this month in the threa
Electronics Forum | Tue Feb 14 10:25:04 EST 2017 | swag
Pre-heat, pre-heat, pre-heat! Swap out your acetylene with some propane. Problem solved. Throw a potato in your solder pot while your at it...
Electronics Forum | Wed Apr 07 18:47:23 EDT 2004 | pdeuel
Thanks to all of you. As it turns out,(pun), the problem was with optimization. The SOT-63 Was being picked with other parts also set to pre orent when orignally this part was not. The program was then optimized. The other parts on the other heads ca
Electronics Forum | Fri Jun 10 11:49:42 EDT 2005 | davef
Steve, We're not so sure that we've had enough of your rant. You say "I think it is the only place that looked pre-SMT for issues that everyone else just assumes is SMT. Any complete solution to SMT changeover times will look at pre-SMT as much as
Electronics Forum | Thu Jan 04 12:51:37 EST 2007 | Board House
Hi Chunks, Starting copper on outer layer with .0007 is 1/2 oz. copper foil. so if starting copper is .0007 and your Board house will plate an additional .0021 mils of copper. which will give you a finished copper weight of .0028 Mils or (2 oz.) Y
