Electronics Forum | Thu Apr 20 16:40:33 EDT 2006 | PWH
All our AP's have camera mounted board stop sensors (works like a conveyor sensor). You can also mount these sensors on or near the conveyor if you want. We do not have problems like you talk about. You should call MpM and ask them if it's possibl
Electronics Forum | Mon Apr 24 13:23:37 EDT 2006 | pjc
Use the photo sensor to stop boards instead of the hard-stop. There is also an ultrasonic sensor upgrade. A little more robust than optical. Y Snugger Tooling upgrade is kind of pricey and they like to do that in the plant. But, I've known that upgr
Electronics Forum | Tue Mar 18 14:13:27 EDT 2008 | chrisgriffin
I know for a fact that you do not need a new computer. Speedline likes to say that about everything. I can have a broken sensor and they say I need a computer upgrade. Their tech. support people tend to be salesmen at times. You just need a newer
Electronics Forum | Thu Sep 08 22:39:20 EDT 2016 | ttheis
Here's an idea; buy a pcb conveyor and design a simple label applicator to mount to it. Maybe replace the logic with your own or replace the PLC in the conveyor with your own solution. Shouldn't be much more than a few sensors and and a stepper motor
Electronics Forum | Thu Aug 22 04:08:17 EDT 2002 | Jason Baldwin
Symptom: Board Stuck on Print Conveyor error messages. Cause: Board not flagging the camera sensor. Remedy: Check the following items: � Check the camera sensor can see the board underneath. � Check the camera sensor calibration (in Tools, Camera Re
Electronics Forum | Tue Aug 03 06:14:18 EDT 2021 | bukas
if blade swapping gives same result try swapping the pressure sensors.
Electronics Forum | Wed Apr 08 10:23:38 EDT 2009 | cyber_wolf
I am assuming this machine has a tactile sensor that mounts to the printing table. If the air connection or any of the wire connectors get under the rear rail it will cause the Z to fall. Also any bare wires on the tactile sensor that touch the prin
Electronics Forum | Thu May 09 10:37:35 EDT 2019 | slthomas
Disclaimer - I know nothing specific about MPM printers. First, a question - have you successfully printed or programmed a print cycle for any other board yet, or is this the first one? I ask because a board stop sensor error sounds like it could b
Electronics Forum | Fri Feb 15 21:52:06 EST 2013 | nikyta
Most likely it is a faulty cable in the e-chain . You can test it in diagnostic: lower the back squeege and manually move back and forth for its entire travel the print carriage while monitoring the sensor output of the squeege. You will see at some
Electronics Forum | Fri Jan 08 14:43:39 EST 2021 | rmitchell
This is good news, maybe the work highlight of the week. I will print this out for my evaluation and see if I can leave early. Glad I was able to help. Rob
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
winsouce.jpg)