Electronics Forum | schurch |
Tue Jan 08 13:46:13 EST 2008
Electronics Forum | Mon Mar 26 17:09:48 EDT 2012 | test_tech
I have an Eclipse 1, that is no longer in production use for pick and place, but I would like to use the the gantry system and install a custom head to perform other tasks. I am looking for some guidance or information on how the existing servo con
Electronics Forum | Tue Mar 27 17:38:23 EDT 2012 | test_tech
I know it's a little bit crazy, but worst case scenario is I buy a new controller, amps, software, and grudgingly maybe even servo motors. Given the cost of buying an equivalent gantry system new, this certainly is a project worth considering, even
Electronics Forum | Tue Nov 13 11:41:23 EST 2012 | dontfeedphils
I can't remember what motor control cards in the machine are interchangeable, but if the controller card for the theta axis is a common control card then you can swap out the one currently controlling the theta axis with a different axis and see if t
Electronics Forum | Fri Nov 03 09:59:46 EST 2000 | Mark Krmpotich
Has anybody done an evaluation on Wave Solder Process Control Modules? I am looking at the ECD WaveRIDER or the Wave Solder Optimizer to try and implement process control on our wave soldering operations. Which is better for controlling the process
Electronics Forum | Fri Mar 15 15:09:36 EST 2002 | Joshua Brown
Are there some good programs that can be used to organize and controle Master Assembly documents? Also help to control Engineering Change Notices (ECN). What are some programs that are being used in the SMT industry at this time for document cont
Electronics Forum | Sat Jun 15 12:20:41 EDT 2002 | jtamagi
What is the value for having humidty controls? I have read the IPC _ 001 standards and it states that the facility requires to be humidty controlled. I agree that a low humidty controls for ESD is important. But, why have an upper limit? what
Electronics Forum | Fri Apr 12 15:48:33 EDT 2002 | jersbo
SPC for each assembly(I use C(for board defects)NP(for unit defects) at the end of reflow to determine process capabilities determine Control limits. Once control limits are set, inspectors stop the process until out of control limit is addressed and
Electronics Forum | Mon Mar 08 11:18:42 EST 2004 | Dave Euser
Hi everyone....I'm a student working on a short research project on industrial control algorithms - and part of the scope that we are looking at is SMT pick and place machines. I was wondering if anyone knows what type of control is used for the no
Electronics Forum | Thu Feb 08 08:45:36 EST 2001 | davef
K: Do you shelf life control rolled solder because of the flux core?
